Hi, SuSE 9.0 accepted files /etc/sysconfig/network/ifcfg-eth0:0 to setup a virtual device eth0:0 with a private IP, while eth0 was the public one. I haven't found a way to do that on SuSE 10.1? If I use the ifcfg-eth0:0 file, eth0:0 is tried to setup during boot, but fails. I tried to configure it with yast, but yast proposes a device "eth-0:0", and when I set this up and call "ifup eth-0:0" afterwards, it says "Interface eth-0:0 is not available". Calling "ifconfig eth0:0 ..." manually works, but I want a config file in /etc/sysconfig/network so that the device is handled automatically. Is this possible? cu, Frank -- Dipl.-Inform. Frank Steiner Web: http://www.bio.ifi.lmu.de/~steiner/ Lehrstuhl f. Bioinformatik Mail: http://www.bio.ifi.lmu.de/~steiner/m/ LMU, Amalienstr. 17 Phone: +49 89 2180-4049 80333 Muenchen, Germany Fax: +49 89 2180-99-4049 * Rekursion kann man erst verstehen, wenn man Rekursion verstanden hat. * --------------------------------------------------------------------- To unsubscribe, e-mail: opensuse+unsubscribe@opensuse.org For additional commands, e-mail: opensuse+help@opensuse.org