-----BEGIN PGP SIGNED MESSAGE----- Hash: SHA1 | If you don't get to step 3 please post the result of the following | commands (from a client and the router): | | ifconfig ghana:~ # ifconfig dsl0 Link encap:Point-to-Point Protocol ~ inet addr:165.146.166.47 P-t-P:165.146.128.1 Mask:255.255.255.255 ~ UP POINTOPOINT RUNNING NOARP MULTICAST MTU:1492 Metric:1 ~ RX packets:961 errors:0 dropped:0 overruns:0 frame:0 ~ TX packets:908 errors:0 dropped:0 overruns:0 carrier:0 ~ collisions:0 txqueuelen:3 ~ RX bytes:400239 (390.8 Kb) TX bytes:119748 (116.9 Kb) eth0 Link encap:Ethernet HWaddr 00:11:09:92:FE:D8 ~ inet addr:10.0.0.9 Bcast:255.255.255.255 Mask:255.0.0.0 ~ inet6 addr: fe80::211:9ff:fe92:fed8/64 Scope:Link ~ UP BROADCAST NOTRAILERS RUNNING MULTICAST MTU:1500 Metric:1 ~ RX packets:1013 errors:0 dropped:0 overruns:0 frame:0 ~ TX packets:988 errors:0 dropped:0 overruns:0 carrier:0 ~ collisions:0 txqueuelen:1000 ~ RX bytes:425549 (415.5 Kb) TX bytes:145802 (142.3 Kb) ~ Interrupt:10 eth1 Link encap:Ethernet HWaddr 00:02:44:5A:82:83 ~ inet addr:192.168.1.250 Bcast:192.168.1.255 Mask:255.255.255.0 ~ inet6 addr: fe80::202:44ff:fe5a:8283/64 Scope:Link ~ UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1 ~ RX packets:70 errors:0 dropped:0 overruns:0 frame:0 ~ TX packets:38 errors:0 dropped:0 overruns:0 carrier:0 ~ collisions:0 txqueuelen:1000 ~ RX bytes:4797 (4.6 Kb) TX bytes:4709 (4.5 Kb) ~ Interrupt:5 Base address:0xc000 lo Link encap:Local Loopback ~ inet addr:127.0.0.1 Mask:255.0.0.0 ~ inet6 addr: ::1/128 Scope:Host ~ UP LOOPBACK RUNNING MTU:16436 Metric:1 ~ RX packets:804 errors:0 dropped:0 overruns:0 frame:0 ~ TX packets:804 errors:0 dropped:0 overruns:0 carrier:0 ~ collisions:0 txqueuelen:0 ~ RX bytes:48336 (47.2 Kb) TX bytes:48336 (47.2 Kb) | route -n ghana:~ # route -n Kernel IP routing table Destination Gateway Genmask Flags Metric Ref Use Iface 165.146.128.1 0.0.0.0 255.255.255.255 UH 0 0 0 dsl0 192.168.1.0 0.0.0.0 255.255.255.0 U 0 0 0 eth1 169.254.0.0 0.0.0.0 255.255.0.0 U 0 0 0 eth0 10.0.0.0 0.0.0.0 255.0.0.0 U 0 0 0 eth0 127.0.0.0 0.0.0.0 255.0.0.0 U 0 0 0 lo 0.0.0.0 165.146.128.1 0.0.0.0 UG 0 0 0 dsl0 | cat /etc/resolv.conf ### BEGIN INFO # # Modified_by: pppd # Backup: /etc/resolv.conf.saved.by.pppd.dsl0 # Process: pppd # Process_id: 4182 # Script: /etc/ppp/ip-up # Saveto: # Info: This is a temporary resolv.conf created by service pppd. # The previous file has been saved and will be restored later. # # If you don't like your resolv.conf to be changed, you # can set MODIFY_{RESOLV,NAMED}_CONF_DYNAMICALLY=no. This # variables are placed in /etc/sysconfig/network/config. # # You can also configure service pppd not to modify it. # # If you do not want the pppd to change your nameserver # settings set MODIFYDNS=no in the config file for # this provider in /etc/sysconfig/network/providers/ # and ensure that the option usepeerdns is not set # in /etc/ppp/options. # ### END INFO search worldviewafrica.org nameserver 196.25.255.34 nameserver 196.25.255.3 | iptables -t nat -n -v -L # (only the router) ghana:~ # iptables -t nat -n -v -L Chain PREROUTING (policy ACCEPT 127 packets, 7408 bytes) ~ pkts bytes target prot opt in out source destination ~ 0 0 REDIRECT tcp -- * * 192.168.1.0/24 0.0.0.0/0 tcp dpt:80 redir ports 6588 ~ 0 0 REDIRECT tcp -- * * 192.168.1.0/24 0.0.0.0/0 tcp dpt:443 redir ports 6588 Chain POSTROUTING (policy ACCEPT 99 packets, 7214 bytes) ~ pkts bytes target prot opt in out source destination ~ 58 2648 MASQUERADE all -- * dsl0 0.0.0.0/0 0.0.0.0/0 Chain OUTPUT (policy ACCEPT 0 packets, 0 bytes) ~ pkts bytes target prot opt in out source destination - -- Raoul Snyman Saturn Laboratories Web: http://www.saturnlaboratories.co.za/ E-mail: raoul.snyman@saturnlaboratories.co.za Blog: http://blog.saturnlaboratories.co.za/ Linux User #333298 (http://counter.li.org/) -----BEGIN PGP SIGNATURE----- Version: GnuPG v1.2.5 (GNU/Linux) Comment: Using GnuPG with Thunderbird - http://enigmail.mozdev.org iD8DBQFCXBtZdabIu5z4rwwRAvCPAKCEIrYtbJFv2+Nz54VK2OlvV2dhzACcCNiJ W4ysREie0pjzTRkiNP1cOZ0= =j3T9 -----END PGP SIGNATURE-----