I recently installed 42.3 on a second computer. This computer has 2 disks. One disk for Leap 42.3 and the other for Windows 10. The install went very smooth (as usual) and I use grub to boot into my disks. I was able to update 42.3 and noticed no issues. Today I went to use the machine and discovered I have no internet. Ifconfig shows I have no address assigned via dhcp. To eliminate a hardware issue I booted into Windows. Windows had internet connectivity. The motherboard is an ASRock H97 Pro4 which uses the Intel gigabyte ethernet chip, the same one used by the machine I am typing from now (leap 42.2). I then switched to a static ip to see if it is a dhcp issue. I used YAST to configure the static ip. Using wicked I was able to start and stop the network successfully. Ifconfig showed my static ip address assigned to eth0. Still no internet. lsmod shows e1000e is loaded. My system consists of a NETGEAR ProSafe™ Gigabit 8 Port VPN Firewall FVS318G router attached to a cable modem. All devices are plugged into the router which assigns ip addresses via dhcp during boot. I have the two computers, a ps3, and a cisco wifi plugged into the router. All are visible to the router and have internet access. On the machine in question when I boot into windows the router shows the computer and assigned ip address(dhcp). When I boot into 42.3 nothing shows up on the router, dhcp or static ip. Any ideas what could be going on? Is there a known problem with the e1000e module? Any ideas will be appreciated. Dave -- To unsubscribe, e-mail: opensuse+unsubscribe@opensuse.org To contact the owner, e-mail: opensuse+owner@opensuse.org