Folks, I'm using ndiswrapper for the wifi driver I need for my Linksys PCMCIA card. I can load ndiswrapper manually with modprobe each time I power up the laptop, and things work fine. But when I run ndiswrapper -m so that it automatically starts during boot-up, I get the following error message in dmesg: ndiswrapper: module not supported by Novell, setting U tain flag. Yet the next two lines show ndiswrapper v. 1.1 loaded, as well as the Linksys driver. The bottom line: I can't get ndiswrapper to activate on start-up, but I can (and do) manually start it with modprobe ndiswrapper after starup. What steps have I failed to take (I followed the SuSE ndiswrapper instructions at Novell's web site)? Best, Pete -- ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~ Peter N. Spotts | Science Correspondent The Christian Science Monitor One Norway Street, Boston MA 02115 Office: 617-450-2449 | Office in home: 508-520-3139 Email: pspotts@alum.mit.edu | www.csmonitor.com ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~