On Mon, 2007-07-30 at 18:32 +0800, Art Fore wrote:
A few months ago, I used my HP Scanjet 5300C on Suse 10.2 with no problems. Now, it is a hit or miss process, mostly miss.
I go to Yast, Hardware, Scanner, the scanner was listed using the avision driver. I do a test, the test passes.
Go to OpenOffice Draw, Insert picture, from scanner,then select scanner. No scanner shows up.
Go to Kooka, it also does not find the scanner. Try Xsane, takes about 10 minutes to get open, but also cannot find the scanner.
Kooka did work one time after going to yast and running a test on the scanner, but then no more.
Nothing shows up in the system log other than where yast installed it when I edited the scanner setup with no changes.
Apparently, one of the upgrades changed something the scanning system does not like. Does anyone have any suggestions on this? I checked the bugzilla report (https://bugzilla.novell.com/show_bug.cgi?id=141079) mentioned in a previous thread, but that does not seem to be quite the same.
System is 64-bit AMD athlon 3200+ with 2 gig of ram.
Art
Tried this again tonight, did get something different. Kooka found scanner, but prescan did not work. Xsane comes up with an error that HewlettPackard:Scanjet5300.drc is not a device-rc-file!!! Couuld not find any info on this file. Is this the problem? If so, where does it come from? File is there in proper path, but it is 0 bytes long. Art -- To unsubscribe, e-mail: opensuse+unsubscribe@opensuse.org For additional commands, e-mail: opensuse+help@opensuse.org