Just finished installing Beta2 on my Thinkpad 390X(P-3/500, 256MB, 40GB). 1. Install went smoothly. Very few dependency issues. (I did not install zypper this time). When I tried to deselct beagle, the only option was beagle-firefox. Is it actually there?(noticed same thing on my PPC install). Speed much better compared to v10.3 2. System was able to start without reboot. Maybe the prior screen should explain that a little better? 3. YaST started in text-mode after installed system came up for hardware config(noticed same issue on my PPC install). 4. Power management still broken. v10.3 did not work either. Possibly a model specific issue. Power management works properly on my Powerbook. I installed KDE 3 as the desktop. I tried KDE 4 on my Powerbook, but it was very different, and I didn't care for the setup. I couldn't figure out how to change stuff. I did not install any eye candy(partly due to low end machine, partly because I don't care for it). Good work devs. I think v11.0 will be a huge improvement over the v10.x series. -- To unsubscribe, e-mail: opensuse+unsubscribe@opensuse.org For additional commands, e-mail: opensuse+help@opensuse.org