On Sunday 02 October 2005 08:24, James Smullins wrote:
Can I install xfree86 from 9.0 in 9.3? or is there a sulution that I did not see via googling?
Hi Jim, FWIW, at the first sign of troubles like this, my approach is to pull the add-in video card and install, fresh, using just the built-in graphics hardware. Then, after the system has been completely installed and properly updated, I try adding the card back in to see if it gets handled any differently... perhaps like an upgrade ought to be handled by a sophisticated operating system. This approach circumvents SaX2 getting misdirected or confused during the initial installation. It also ensures it is using the latest hardware database when probing and identifying the added-in "upgrade" card. Another benefit is it gets the system to a stable point where the built-in hardware is fully 'hooked' and (hopefully) controlled, as opposed to possibly acting like a phantom limb... physically attached but not configured or disabled correctly due to an inadequate (windoze only) or buggy BIOS "off" mechanism. regards, - Carl