On Tuesday 05 June 2007 02:46:36 pm Eberhard Roloff wrote:
Carlos F Lange wrote:
On Tue June 5 2007 07:33, Rainer Brinkmann wrote:
Perhaps the cable dropped down.
No cable problem. That is exactly what is killing me. The lights on the router are on (also when I changed ports and cable) and when I reboot into Windows the DHCP servers hands out the usual IP address immediately. It is only in Linux, after it worked with this network card for 2 days, that the problem happens. There is no error message on the router, and the logs in /var/log only indicate that the network is down and that the DHCP client is still waiting.
What else can I try?
CFL
Hi,
I once experienced the exact same problem. For the heart of it I could not find out why it did not work in Linux while it worked in Windows and did work in Linux, before. (it was a dlink-530, I believe).
What made it work in Linux: 1. Take out the board 2. Start Linux with no network card installed and delete anything that might have been left over (I did that in yast) 3. Start Linux, once again and see, whether there REALLY is NO network card detected and no remaining settings. 4. install the card physically, once again 5. Fire up Linux and let it autodetect the network card.
I cannot guarantee anything, but it did the trick for me.
If anything else fails I would install a different network card and see, how this works. After all, network boards for desktop usage nowadays are a commoditiy, more or less.
kind regards Eberhard
The above is probably your best bet, especially if the card was setup in Linux before Windows. If you set it up in Linux first, then in Windows, there is a high chance that the NIC ROM got flashed with an update. This could have come from the Windows installation software, Windows Update may have changed something, or you may have flashed the card on you own accord. If the above suggestion does not work, I would exchange that card for a known working card from one of your other machines, and see if that works out. In general, I would set up hardware in Windows first, if using a dual boot machine. That way any changes that Windows makes to the hardware will occur before setting up the same hardware in Linux. - James W -- To unsubscribe, e-mail: opensuse+unsubscribe@opensuse.org For additional commands, e-mail: opensuse+help@opensuse.org