My Adaptec Scsi card is not detected anymore. I get this message during boot: "Atapi device hdd" "error - bot ready - sense key = 0x02" "(reserved error code " {thanks guys, this really helps} "-- asc=0x30, asco=ax01)" "The failed "read cd/dvd capacity" packet was "25 00 00 00 00 00 00 00 00 00 00 00 " I should explain that I have an IDE DVD on hdc, and an IDE CD writer on hdd; scsi emulation is enabled,; and the two drives have been working fine for quite some time. So I booted on the SuSE DVD, aborted the installation, chose "load modules", selected the AIC7XXX scsi module, and got an error message, complaining that the module could not be loaded, followed by the very same message I quoted earlier, which appears on every boot. After which the module is loaded anyway (I checked with: "check loaded modules" or whatever the command is. And the scanner works. But if I reboot, all is lost (I mean, the Scsi card...). Scsi emulation works fine, I can burn CD's. But why isn't the Scsi card detected anymore, and what can I do to load it? Thanks FX -- ______________________ Courtesy of SuSE Linux Kernel 2.2.18 (who Kares?)