Greetings, Following my previous mail about the following messages during boot:
<4>PCI_IDE: unknown IDE controller on PCI bus 00 device 78, VID=10b9, DID=5229 <4>PCI_IDE: not 100% native mode: will probe irqs later <4>PCI_IDE: simplex device: DMA disabled <4>ide0: PCI_IDE Bus-Master DMA disabled (BIOS) <4>PCI_IDE: simplex device: DMA disabled <4>ide1: PCI_IDE Bus-Master DMA disabled (BIOS) <4>hda: IBM-DTTA-350640, ATA DISK drive <4>hdb: ST34321A, ATA DISK drive
I downloaded the 2.2.13 kernel sources and applied Andre Hedrick's udma patch. This all went fine but now I see these messages on boot: <4>ALI15X3: IDE controller on PCI bus 00 dev 78 <4>ALI15X3: not 100% native mode: will probe irqs later <4>ALI15X3: simplex device: DMA disabled <4>ide0: ALI15X3 Bus-Master DMA disabled (BIOS) <4>ALI15X3: simplex device: DMA disabled <4>ide1: ALI15X3 Bus-Master DMA disabled (BIOS) On ide0 I have 2 disk attached: <4>hda: IBM-DTTA-350640, ATA DISK drive <4>hdb: Maxtor 90871U2, ATA DISK drive The second disk is supposed to support udma. As far as I can see my BIOS is setup to allow udma as far as I can tell. Anyone know why I'm getting DMA disabled. My PC details are: AMD K6-III 450MHz ASUS P5A Super7 Motherboard 128MB SDRAM SuSE 6.1 Regards, Roy -- To unsubscribe send e-mail to suse-linux-e-unsubscribe@suse.com For additional commands send e-mail to suse-linux-e-help@suse.com Also check the FAQ at http://www.suse.com/Support/Doku/FAQ/