Hallo zusammen, weiß wirklich keiner was über diese Fehlermedlungen? (Konfiguration: Laptop 433 MHz Intel Celeron mit MMX mit 186 MB SD 133 Ram, ..., internes 56k Modem (PCI) und SuSE Linux 8.1 Professional (ohne Veränderungen)) Meine xconsole zeigt folgende Meldungen nach dem Booten an: ...: usb-uhci.c: Detected 2 ports ...: usb.c: USB device 2 (vend/prod 0x45e/0x25) is not claimed by any active driver. ...: usb-uhci.c: interrupt, status 3, frame# 421 ...: usb-uhci.c: ENXIO 84000280, flags 0, urb c2216320, burb c2216220 ...: last message repeated 4 times ich habe aber nur 1 USB Slot?!? ...: Yenta IRQ list 0a98, PCI irq10 (ist das mein nicht erkanntes Modem?) ...: Socket status: 30000006 ...: Yenta IRQ list 0a98, PCI irq10 ...: Socket status: 3000010 ...: hdc: bad special flag: 0x03 (was soll denn das sein?? hdc ist mein internes CD LW) ...: ide-floppy driver 0.99.newide ...: hdc: no flushcach support ...: ATAPI 24X CD-ROM drive, 128kB Cache ...: hdc: packet command error: status=0x51 { DriveReady SeekComplete Error} ...: hdc: packet command error: error=0x54 ...: ATAPI device hdc: ...: Error: Illegal request -- (Sense key=0x05) ...: Invalid field in command packet -- (asc=0x24, ascq=0x00) ...: The failed "Start/Stop Unit" packet command was: ...: "1b 00 00 00 03 00 00 00 00 00 00 00 " ...: Error in command packet byte 4 bit 0 Was kann ich dagegen machen, weiß jmd. wie ich diese Meldungen (und die Fehler korrigiere) wegbringe? Gruß Richard
participants (1)
-
Richard Henker