Hi Liste! Welches DCF77-Modul von Conrad ist in der Datei /etc/ntp.conf gemeint ??? Könnt Ihr mir unter Umstaenden die Bestellnummer mailen?? mfg Kai -- Um aus der Liste ausgetragen zu werden, eine Mail an majordomo@suse.com schicken, mit dem Text: unsubscribe suse-linux
Kai Rutz wrote:
Hi Liste!
Welches DCF77-Modul von Conrad ist in der Datei /etc/ntp.conf gemeint ??? Könnt Ihr mir unter Umstaenden die Bestellnummer mailen??
damit ist das smd-modul mit der bestellnummer 19.... gemeint. antenne nicht vergessen. aber: ich habe es selbst mal versucht dieses ding incl. der für die schnittstellen-anbindung nötigen treiber als laufen zu kriegen. war leider nix. mittlerweile läufts, aber nicht mit dem DCF77-modul von conrad, sondern einem uralt-dcf-empfänger (so. ca. 10 Jahre alt, von völkner, mit LED-Digits und so...) alter ist eigentlich egal. du kannst so ziemlich _jeden_ Funkwecker nehmen. wenn du da mal reinschaust, wirst du erkennen, wo der proz zum dekodieren liegt, nämlich mit quarz und antettenanschluß zusammen. von dort sind es eigentlich immer nur so 2-3 leitungen. wenn du die mal testweise der reihe nach auf GND ziehst und dann mit einem multimeter die leitung misst, die zum lcd-trieber chip führt, wirst du eine art "pulsen" messen können (0-Batteriespannung). jetzt musst du noch diese 1.5V (batteriespannung) auf V24 niveau bringen, also irgendwas zwischen +-5 bis +-15V. Das kannst du mit einem OP oder einer darlington-stufe bewerkstelligen. die spannungen holst du dir von deinem v-24 port, dort kannst du auch die spannung für dein modul oder halt funkwecker abgreifen. wenn du die impulse hast (100 oder 200ms lang, flanke auf der sekunde, pause auf der 59. sekunde zur anzeige des minutenbeginns) legst du dieses signal auf die RxD-Leitung deines v24 ports (bei mir tuts auch der wechel zwischen 0 und ca. +7V) legst du einen link unter /dev an, und zwar als refclock-0, der auf den Port zeigt, an dem dein DCF-signal liegt. dann in ntp.conf folgendes eintragen: erver 127.127.8.0 mode 5 prefer (.0 für refclock-0, prefer kann man sich auch schenken) fudge 127.127.8.0 stratum 1 (protz...) das wars eigentlich. defaults fürs logging reichen. kannst dann nach reload des xntpd mit tail -f /var/log/ntp.log (oder wie dein logfile auch heissen mag...) zuscheuen, wie sich xntpd synchronisiert bzw. mögliche fehler ansehen. ntp.drift nicht verändern, wird ehŽ von xntpd gesetzt um eigene clockdrift des motherboards auszugleichen. brgds carsten -- Um aus der Liste ausgetragen zu werden, eine Mail an majordomo@suse.com schicken, mit dem Text: unsubscribe suse-linux
participants (2)
-
cguenther@guenthers.net
-
krutz@rhrk.uni-kl.de