Hallo, nachdem ich meinen Desktop-PC mit 11.3 64Bit neu eingerichtet habe, habe ich jetzt folgendes Problem: Wlan lässt sich nur per Knetworkmanager starten, nicht per ifup. Das Scanning der AP in der Umgebung funktioniert, allerdings wird kein DHCP-Lease vergeben. Da es sich nur um einen DesktopPC handelt, würde ich gern wieder auf ifup umstellen. Unter 11.2 hat es anstandslos funktioniert. Hier mal ein Auszug aus /v/l/m: 2010-07-18 19:08:03 linux avahi-daemon[1824] Interface wlan0.IPv4 no longer relevant for mDNS. 2010-07-18 19:08:03 linux avahi-daemon[1824] Leaving mDNS multicast group on interface wlan0.IPv4 with address 192.168.178.23. 2010-07-18 19:08:03 linux avahi-daemon[1824] Withdrawing address record for fe80::21f:1fff:fe26:71b8 on wlan0. 2010-07-18 19:08:03 linux avahi-daemon[1824] Withdrawing address record for 192.168.178.23 on wlan0. 2010-07-18 19:08:03 linux ifdown Network interface is managed by the NetworkManager -> skipping 2010-07-18 19:08:03 linux ifdown wlan0 device: RaLink RT2860 Wireless 802.11n PCIe 2010-07-18 19:08:04 linux dhcpcd[8833] wlan0: dhcpcd not running 2010-07-18 19:08:04 linux dhcpcd[8833] wlan0: exiting 2010-07-18 19:08:04 linux dhclient Bound to *:546 2010-07-18 19:08:06 linux ifup lo 2010-07-18 19:08:06 linux ifup lo 2010-07-18 19:08:06 linux ifup IP address: 127.0.0.1/8 2010-07-18 19:08:06 linux ifup 2010-07-18 19:08:06 linux ifup 2010-07-18 19:08:06 linux ifup IP address: 127.0.0.2/8 2010-07-18 19:08:06 linux ifup 2010-07-18 19:08:06 linux ifup eth0 device: Realtek Semiconductor Co., Ltd. RTL8111/8168B PCI Express Gigabit Ethernet controller (rev 02) 2010-07-18 19:08:06 linux ifup No configuration found for eth0 2010-07-18 19:08:07 linux ifup wlan0 device: RaLink RT2860 Wireless 802.11n PCIe 2010-07-18 19:08:07 linux ifup-wireless wlan0 warning: WPA configured but may be unsupported 2010-07-18 19:08:07 linux ifup-wireless wlan0 warning: by this device 2010-07-18 19:08:07 linux ifup-wireless wlan0 starting wpa_supplicant 2010-07-18 19:08:07 linux kernel [ 4899.080724] RX DESC ffff880052a3e000 size = 2048 2010-07-18 19:08:07 linux kernel [ 4899.080891] <-- RTMPAllocTxRxRingMemory, Status=0 2010-07-18 19:08:07 linux kernel [ 4899.082879] 1. Phy Mode = 0 2010-07-18 19:08:07 linux kernel [ 4899.082880] 2. Phy Mode = 0 2010-07-18 19:08:07 linux kernel [ 4899.100062] 3. Phy Mode = 0 2010-07-18 19:08:07 linux kernel [ 4899.102859] MCS Set = 00 00 00 00 00 2010-07-18 19:08:07 linux kernel [ 4899.104496] <==== rt28xx_init, Status=0 2010-07-18 19:08:07 linux kernel [ 4899.104565] 0x1300 = 000a4200 2010-07-18 19:08:07 linux ifup-dhcp wlan0 Starting DHCP4+DHCP6 client 2010-07-18 19:08:07 linux dhcpcd[9411] wlan0: dhcpcd 3.2.3 starting 2010-07-18 19:08:07 linux dhcpcd[9411] wlan0: hardware address = 00:1f:1f:26:71:b8 2010-07-18 19:08:07 linux dhcpcd[9411] wlan0: broadcasting for a lease 2010-07-18 19:08:08 linux ifup-dhcp . 2010-07-18 19:08:08 linux dhclient Bound to *:546 2010-07-18 19:08:09 linux dhclient XMT: Solicit on wlan0, interval 1090ms. 2010-07-18 19:08:09 linux dhclient send_packet6: Cannot assign requested address 2010-07-18 19:08:09 linux dhclient dhc6: send_packet6() sent -1 of 54 bytes 2010-07-18 19:08:09 linux avahi-daemon[1824] Registering new address record for fe80::21f:1fff:fe26:71b8 on wlan0.*. 2010-07-18 19:08:10 linux dhclient XMT: Solicit on wlan0, interval 2190ms. 2010-07-18 19:08:10 linux ifup-dhcp . 2010-07-18 19:08:12 linux dhclient XMT: Solicit on wlan0, interval 4420ms. 2010-07-18 19:08:13 linux ifup-dhcp . 2010-07-18 19:08:16 linux ifup-dhcp . 2010-07-18 19:08:16 linux dhclient XMT: Solicit on wlan0, interval 9050ms. 2010-07-18 19:08:18 linux kernel [ 4909.826034] wlan0: no IPv6 routers present 2010-07-18 19:08:18 linux ifup-dhcp . 2010-07-18 19:08:21 linux ifup-dhcp . 2010-07-18 19:08:23 linux ifup-dhcp . 2010-07-18 19:08:25 linux dhclient XMT: Solicit on wlan0, interval 17860ms. 2010-07-18 19:08:26 linux ifup-dhcp . 2010-07-18 19:08:27 linux ifup-dhcp 2010-07-18 19:08:27 linux ifup-dhcp wlan0 DHCP4 continues in background 2010-07-18 19:08:27 linux ifup-dhcp wlan0 DHCP6 continues in background 2010-07-18 19:08:27 linux SuSEfirewall2 Setting up rules from /etc/sysconfig/SuSEfirewall2 ... 2010-07-18 19:08:27 linux SuSEfirewall2 batch committing... 2010-07-18 19:08:27 linux SuSEfirewall2 Firewall rules successfully set 2010-07-18 19:08:27 linux dhcpcd[9411] wlan0: timed out 2010-07-18 19:08:27 linux dhcpcd[9411] wlan0: trying to use old lease in `/var/lib/dhcpcd/dhcpcd-wlan0.info' 2010-07-18 19:08:27 linux dhcpcd[9411] wlan0: broadcasting for a lease 2010-07-18 19:08:34 linux kernel [ 4926.027058] r8169 0000:03:00.0: eth0: link down 2010-07-18 19:08:34 linux kernel [ 4926.027395] ADDRCONF(NETDEV_UP): eth0: link is not ready 2010-07-18 19:08:43 linux dhclient XMT: Solicit on wlan0, interval 36680ms. 2010-07-18 19:08:47 linux dhcpcd[9411] wlan0: timed out 2010-07-18 19:08:47 linux dhcpcd[9411] wlan0: trying to use old lease in `/var/lib/dhcpcd/dhcpcd-wlan0.info' 2010-07-18 19:08:47 linux dhcpcd[9411] wlan0: broadcasting for a lease 2010-07-18 19:09:07 linux dhcpcd[9411] wlan0: timed out 2010-07-18 19:09:07 linux dhcpcd[9411] wlan0: trying to use old lease in `/var/lib/dhcpcd/dhcpcd-wlan0.info' 2010-07-18 19:09:07 linux dhcpcd[9411] wlan0: broadcasting for a lease 2010-07-18 19:09:20 linux dhclient XMT: Solicit on wlan0, interval 71730ms. Die Wlan-Karte ist eine Logilink PCI-E Karte mit Ralink-Chipsatz, benutzt wird rt2860sta. Achso, noch ein Hinweis; ich musste bei der FritzBox 7270 die WLAN- Verschlüsselungsmethode fest auf WPA2 stellen. Mit der Einstellung WPA/WPA2 kam keine Verbindung zustande. Anscheinend funktionierte dort die Aushandelung der Verschlüsselung nicht. Viele Grüße Steffen -- Um die Liste abzubestellen, schicken Sie eine Mail an: opensuse-de+unsubscribe@opensuse.org Um eine Liste aller verfuegbaren Kommandos zu bekommen, schicken Sie eine Mail an: opensuse-de+help@opensuse.org