Hi hallo und guten Abend ich kämpfe hier gerade mit meiner Installation auf nem Toshiba Notebook 5100-201. Suse 8.0 Pro, Installation klappte problemlos. Nur - die Tastaturwiederholfrequenz ist viel zu hoch. Es gelingt mir kaum, ein einzelnes Zeichen über die Tastatur einzugeben. Diese erscheinen immer gleich doppelt und dreifach.... Wo kann ich das einstellen? Vielen Dank mit netten Grüßen Detlef Moebus
Hallo, On Sun, 09 Jun 2002, Detlef Moebus wrote:
ich kämpfe hier gerade mit meiner Installation auf nem Toshiba Notebook 5100-201. Suse 8.0 Pro, Installation klappte problemlos. Nur - die Tastaturwiederholfrequenz ist viel zu hoch. Es gelingt mir kaum, ein einzelnes Zeichen über die Tastatur einzugeben. Diese erscheinen immer gleich doppelt und dreifach....
Wo kann ich das einstellen?
1. Im BIOS 2. man setterm/man stty 3. xset r rate ... -dnh -- "I love the way Microsoft follows standards. In much the same manner that fish follow migrating caribou." -- Paul Tomblin, in ASR
On Mon, 10 Jun 2002 at 06:28 (+0200), David Haller wrote:
On Sun, 09 Jun 2002, Detlef Moebus wrote:
ich kämpfe hier gerade mit meiner Installation auf nem Toshiba Notebook 5100-201. Suse 8.0 Pro, Installation klappte problemlos. Nur - die Tastaturwiederholfrequenz ist viel zu hoch. Es gelingt mir kaum, ein einzelnes Zeichen über die Tastatur einzugeben. Diese erscheinen immer gleich doppelt und dreifach....
Wo kann ich das einstellen?
1. Im BIOS
Sicher, dass das nicht wieder überschrieben wird. Immerhin überschreibt Linux auch die Einstellungen bzgl. NumLock. Gruß, Bernhard -- 93 Prozent der Amerikaner wissen, dass Rauchen Lungenkrebs verursacht, aber nur 48 Prozent wissen, dass es ein Jahr dauert, bis die Erde einmal um die Sonne gekreist ist. (Quelle: HSIA-Preprint)
Hallo Detlef, hallo Leute, Am Sonntag, 9. Juni 2002 22:23 schrieb Detlef Moebus:
Suse 8.0 Pro, Installation klappte problemlos. Nur - die Tastaturwiederholfrequenz ist viel zu hoch. [...] Wo kann ich das einstellen?
Bei SuSE 7.3 ging das über die /etc/rc.config # keyboard repeat rate (2.0 - 30.0) # keyboard delay time in ms (250, 500, 750, 1000) # (If you want "kbdrate" to be executed, you have to set both of them.) # KBD_RATE="" KBD_DELAY=" greppe einfach mal in /etc/sysconfig und Unterverzeichnissen (keyboard?) nach den Variablen KBD_RATE und KBD_DELAY, dort solltest Du eigentlich fündig werden ;-) Gruß Christian Boltz -- Registrierter Linux-Nutzer #239431 Linux - life is too short for reboots.
participants (4)
-
Bernhard Walle
-
Christian Boltz
-
David Haller
-
Detlef Moebus