<PRE> Hallo, ich hab ein Problem mit meinem X-Server. nach kurzer Zeit, meist nachdem ich etwas mit der Maus "gewackelt" habe bleibt X stehen und es hilft nur noch ein Reset !! Meine Konfiguration: 5x86-S Cyrix 100 MHz, 16 MB Extended Memory 128 K Cache Memory Advance Logic ALG - 2302 Grafikkarte mit 1024 KDRAM Swap: 30 MB Microsoft Bus Maus fvwm95 - SVGA Server mit 256 Farben. Hab ich vielleicht zu wenig Hauptspeicher ? das kleine Fenster zeigt 14 M an Swap ist bei 5.2 M Attached hab ich die Meldungen von startx sowie meine XF86Config. Vielen Dank Uli </PRE> <PRE> XFree86 Version 3.3.3 / X Window System (protocol Version 11, revision 0, vendor release 6300) Release Date: November 18 1998 If the server is older than 6-12 months, or if your card is newer than the above date, look for a newer version before reporting problems. (see <A HREF="http://www.XFree86.Org/FAQ"><A HREF="http://www.XFree86.Org/FAQ</A">http://www.XFree86.Org/FAQ</A</A>>) Operating System: Linux 2.1.129 i686 [ELF] Configured drivers: SVGA: server for SVGA graphics adaptors (Patchlevel 0): NV1, STG2000, RIVA128, RIVATNT, ET4000, ET4000W32, ET4000W32i, ET4000W32i_rev_b, ET4000W32i_rev_c, ET4000W32p, ET4000W32p_rev_a, ET4000W32p_rev_b, ET4000W32p_rev_c, ET4000W32p_rev_d, ET6000, ET6100, et3000, pvga1, wd90c00, wd90c10, wd90c30, wd90c24, wd90c31, wd90c33, gvga, ati, sis86c201, sis86c202, sis86c205, sis86c215, sis86c225, sis5597, sis5598, sis6326, tvga8200lx, tvga8800cs, tvga8900b, tvga8900c, tvga8900cl, tvga8900d, tvga9000, tvga9000i, tvga9100b, tvga9200cxr, tgui9400cxi, tgui9420, tgui9420dgi, tgui9430dgi, tgui9440agi, cyber9320, tgui9660, tgui9680, tgui9682, tgui9685, cyber9382, cyber9385, cyber9388, cyber9397, cyber9520, 3dimage975, 3dimage985, clgd5420, clgd5422, clgd5424, clgd5426, clgd5428, clgd5429, clgd5430, clgd5434, clgd5436, clgd5446, clgd5480, clgd5462, clgd5464, clgd5465, clgd6205, clgd6215, clgd6225, clgd6235, clgd7541, clgd7542, clgd7543, clgd7548, clgd7555, clgd7556, ncr77c22, ncr77c22e, cpq_avga, mga2064w, mga1064sg, mga2164w, mga2164w AGP, mgag200, mgag100, oti067, oti077, oti087, oti037c, al2101, ali2228, ali2301, ali2302, ali2308, ali2401, cl6410, cl6412, cl6420, cl6440, video7, ark1000vl, ark1000pv, ark2000pv, ark2000mt, mx, realtek, s3_virge, AP6422, AT24, AT3D, s3_svga, NM2070, NM2090, NM2093, NM2097, NM2160, NM2200, ct65520, ct65525, ct65530, ct65535, ct65540, ct65545, ct65546, ct65548, ct65550, ct65554, ct65555, ct68554, ct69000, ct64200, ct64300, mediagx, V1000, V2x00, p9100, spc8110, generic (using VT number 7) XF86Config: /etc/XF86Config (**) stands for supplied, (--) stands for probed/default values (**) XKB: rules: "xfree86" (**) XKB: model: "pc104" (**) XKB: layout: "us" (**) XKB: keymap: "xfree86(de)" (overrides other XKB settings) (**) Mouse: type: Microsoft, device: /dev/mouse, baudrate: 1200 (**) Mouse: samplerate: 60, buttons: 3 (**) Mouse: 3 button emulation (timeout: 50ms) (**) SVGA: Graphics device ID: "Avance" (**) SVGA: Monitor ID: "Monitor" (--) SVGA: Mode "1152x864" needs vert refresh rate of 44.46 Hz. Deleted. (--) SVGA: Mode "1600x1000" needs hsync freq of 28.80 kHz. Deleted. (--) SVGA: Mode "1280x960" needs vert refresh rate of 35.89 Hz. Deleted. (--) SVGA: Mode "1600x1200" needs hsync freq of 28.80 kHz. Deleted. (--) SVGA: Mode "1280x1024" needs vert refresh rate of 33.64 Hz. Deleted. (--) SVGA: Mode "1024x768" needs vert refresh rate of 120.01 Hz. Deleted. (**) FontPath set to "/usr/X11R6/lib/X11/fonts/misc,/usr/X11R6/lib/X11/fonts/75dpi:unscaled,/usr/X11R6/lib/X11/fonts/100dpi:unscaled,/usr/X11R6/lib/X11/fonts/Type1,/usr/X11R6/lib/X11/fonts/Speedo,/usr/X11R6/lib/X11/fonts/75dpi,/usr/X11R6/lib/X11/fonts/100dpi,/usr/X11R6/lib/X11/fonts/local/,/usr/X11R6/lib/X11/fonts/misc/,/usr/X11R6/lib/X11/fonts/75dpi/:unscaled,/usr/X11R6/lib/X11/fonts/100dpi/:unscaled,/usr/X11R6/lib/X11/fonts/Type1/,/usr/X11R6/lib/X11/fonts/Speedo/,/usr/X11R6/lib/X11/fonts/75dpi/,/usr/X11R6/lib/X11/fonts/100dpi/" (--) SVGA: PCI: Unknown vendor (0x4005) Unknown chipset (0x2302) rev 0, Memory @ 0xfc000000 (--) SVGA: chipset: al2101 (**) SVGA: videoram: 1024k (--) SVGA: clocks: 24.78 28.32 22.13 35.40 37.17 31.86 38.94 39.83 (**) SVGA: Option flag "16clocks" is not defined for this driver (**) SVGA: Using 8 bpp, Depth 8, Color weight: 666 (--) SVGA: Maximum allowed dot-clock: 90.000 MHz (**) SVGA: Mode "800x600": mode clock = 40.000, clock used = 39.830 (**) SVGA: Virtual resolution set to 800x600 (--) SVGA: SpeedUp code selection modified because virtualX != 1024 (**) Adding extended device "SWITCH" (type: Switch) xrdb: "*XmText.Translations" on line 13 overrides entry on line 10 X connection to :0.0 broken (explicit kill or server shutdown). X connection to :0.0 broken (explicit kill or server shutdown). X connection to :0.0 broken (explicit kill or server shutdown). xterm: fatal IO error 32 (Broken pipe) or KillClient on X server ":0.0" X connection to :0.0 broken (explicit kill or server shutdown). X connection to :0.0 broken (explicit kill or server shutdown). xterm: fatal IO error 32 (Broken pipe) or KillClient on X server ":0.0" xinit: connection to X server lost. waiting for X server to shut down .. </PRE> <A HREF="bin00006.bin"> XF86CONF</A></P>