H@llo Liste! -------- Original Message -------- From: markus.kossmann@inka.de
Also folgendes... habe hier einen Rechner mit einem ASUS P2B-S Mainboard, der eben einen A2940 (aic7xxxx) onboard hat. An diesem Controller hängen 2 Festplatten (als LVM-Set) und ein SCSI-II-DAT-Streamer (Sony SDT7000).
Ich bekomme nach dem Start immer die folgenden Fehlermeldungen:
scsi0: PCI Error interrupt at seqaddr = 0x9 scsi0: Data Parity Error Detected during address or write data phase
Bist du sicher das deine Verkabelung in Ordnung ist ( Kabel nicht beschädigt ?, Kabellänge innerhalb der Specs ? , Terminierung ?)
Die Kabel sind absolut in Ordnung. Habe andere ausprobiert und da kommt das Gleiche raus. Inzwischen bin ich soweit, dass ich an einen Defekt des SCSI-Controllers glaube. Habe nämlich noch einen weiteren Adaptec dazugesteckt (PCI, ebenfalls aic7xxxx) und der funktioniert einwandfrei. Naja, das Board ist ja auch alt genug. ;/ Ich überlege sowieso, ob ich nicht auf einen schnelleren Server umsteige. In den wollte ich dann eigentlich einen Adaptec 2100S-RAID stecken, damit ich Hardware-RAID habe (SoftRAID ist ja nicht ganz so dolle). Bis denne... Olly. -- Oliver Schaper linux@gtse.de
* linux@gtse.de schrieb am Dienstag, 2002-11-19:
scsi0: PCI Error interrupt at seqaddr = 0x9 scsi0: Data Parity Error Detected during address or write data phase
Das hatte ich auf einem Board, das mich geradezu zur Verzweiflung getrieben hat. Am Ende stellte sich heraus, daß es nicht am SCSI- Controller (Adaptec 29160) lag, sondern unerklärlicherweise daran, daß dem IDE-Controller zwei Festplatten am primären Kanal nicht schmeckten. Sobald ich sie auf beide Kanäle verteilt hatte, ging es wieder. Das Board war allerdings ein etwas neueres von Gigabyte. -- Christian Ullrich Registrierter Linux-User #125183 "Deliver."
Am Dienstag, 19. November 2002 14:17 schrieb linux@gtse.de:
Die Kabel sind absolut in Ordnung. Habe andere ausprobiert und da kommt das Gleiche raus. Inzwischen bin ich soweit, dass ich an einen Defekt des SCSI-Controllers glaube. Habe nämlich noch einen weiteren Adaptec dazugesteckt (PCI, ebenfalls aic7xxxx) und der funktioniert einwandfrei.
Wie sieht es denn mit der Terminierung aus? Wird ja bei OnBoard HA normalerweise im BIOS geregelt. -- Machs gut | http://www.iivs.de/schwinde/buerger/tremmel/ Manfred | http://www.knightsoft-net.de
participants (3)
-
Christian Ullrich
-
linux@gtse.de
-
Manfred Tremmel