Hallo! Ich habe 2 Netzwerkkarten in meinem Rechner, eine (eth0) ist mit dem lokalen Netzwerk verbunden, die andere (eth1) hängt an einem Hausnetzwerk und bezieht über DHCP ihre IP. Nun bekomme ich beim booten folgende Meldung: <snip> DHCLIENT: The device eth1 is not available at the moment DHCLIENT: Please check if the driver is set up correctly setting up network device eth0 done <snap> eth1 (eine NE2000-ISA-Karte) ist in der /etc/modules.conf eingetragen mit "alias eth1 ne" und "options ne 0x280". Wenn ich nach dem Booten "modprobe ne; init 1; init 2" mache, läuft alles wunderbar. Eigentlich müßte das "modprobe ne" doch beim Booten automatisch gemacht werden, oder? Norbert -- Sent through GMX FreeMail - http://www.gmx.net
Norbert Stuhrmann schrieb am 29.01.2001:
eth1 (eine NE2000-ISA-Karte) ist in der /etc/modules.conf eingetragen mit "alias eth1 ne" und "options ne 0x280".
Fehlt da nicht eine IRQ-Angabe? hth, Christian -- Made with a Macintosh... ChriSchmi@t-online.de http://home.t-online.de/home/chrischmi/
Christian Schmitt schrieb:
Fehlt da nicht eine IRQ-Angabe?
Nöö, "modprobe ne" lädt das Modul ja ohne Prob. Norbert -- Sent through GMX FreeMail - http://www.gmx.net
participants (2)
-
Christian Schmidt
-
Norbert Stuhrmann