Am Sonntag, 13. März 2005 15:35 schrieb Guido Pinkernell:
sda: unknown partition table Attached scsi removable disk sda at scsi4, channel 0, id 0, lun 0 Attached scsi generic sg0 at scsi4, channel 0, id 0, lun 0, type 0 USB Mass Storage device found at 10
Wie man sieht, wird die Partitionstabelle nicht erkannt. Trotzdem kann ich ja per Hand mounten. Vielleicht liegt das ganze Problem ja in dieser Fehlermeldung begründet.
Ich habe jetzt mal meinen anderen Stick versucht. Die dmesg sieht so aus: USB Mass Storage device found at 10 usb 3-1: USB disconnect, address 10 usb 4-5: new high speed USB device using address 8 usb 4-5: Product: Twist usb 4-5: Manufacturer: SWISSBIT usb 4-5: SerialNumber: 40D5FDB7171115B4 scsi5 : SCSI emulation for USB Mass Storage devices Vendor: SWISSBIT Model: Twist Rev: 2.00 Type: Direct-Access ANSI SCSI revision: 02 sda: Unit Not Ready, sense: Current : sense key Unit Attention Additional sense: Not ready to ready change, medium may have changed sda : READ CAPACITY failed. sda : status=1, message=00, host=0, driver=08 Current sd: sense key Unit Attention Additional sense: Not ready to ready change, medium may have changed sda: test WP failed, assume Write Enabled sda: assuming drive cache: write through sda: Unit Not Ready, sense: Current : sense key Unit Attention Additional sense: Not ready to ready change, medium may have changed SCSI device sda: 254720 512-byte hdwr sectors (130 MB) sda: Write Protect is off sda: Mode Sense: 03 00 00 00 sda: assuming drive cache: write through SCSI device sda: 254720 512-byte hdwr sectors (130 MB) sda: Write Protect is off sda: Mode Sense: 03 00 00 00 sda: assuming drive cache: write through sda: sda: Attached scsi removable disk sda at scsi5, channel 0, id 0, lun 0 Attached scsi generic sg0 at scsi5, channel 0, id 0, lun 0, type 0 USB Mass Storage device found at 8 Hier gibts offensichtlich verschiedene Fehlermeldungen den node sda betreffend. Interessanterweise gibts bei mir gar keinen Devicenode /dev/sda oder /dev/sda1. Die Fehlermeldungen scheinen wohl daher zu rühren. Nur: Das Adminhandbuch zu 9.2 sagt, dass für udev solche Nodes gar nicht existieren müssen. Die werden von udev ja selbst angelegt. Nach meiner udev-Regel werden die notwendigen Nodes aber mit einem anderen Namen angelegt. Und diese Nodes werden vom System wohl komplett ignoriert. Muss ich denn udev noch irgendwo im System anmelden? Guido