Hallo, Jan Ritzerfeld wrote:
Naja, der Bug ist scheinbar eben nicht gefixt, ich würde das dann mal in einem Kommentar den Entwicklern mitteilen!
wen muss man "anmailen" ?
BTW, du schreibst, daß du den ipw3945-Treiber benutzen würdest. Bist du dir da sicher? Oder ist das nur ein Tippfehler? Was sagt "hwinfo --wlan"?
work:> hwinfo --wlan 22: PCI 300.0: 0282 WLAN controller [Created at pci.301] UDI: /org/freedesktop/Hal/devices/pci_8086_4227 Unique ID: JNkJ.mAONicWAIr5 Parent ID: qTvu._Y5kuEY+GiC SysFS ID: /devices/pci0000:00/0000:00:1c.1/0000:03:00.0 SysFS BusID: 0000:03:00.0 Hardware Class: network Model: "Intel Thinkpad X60s, R60e model 0657" Vendor: pci 0x8086 "Intel Corporation" Device: pci 0x4227 "PRO/Wireless 3945ABG Network Connection" SubVendor: pci 0x8086 "Intel Corporation" SubDevice: pci 0x1011 "Thinkpad X60s, R60e model 0657" Revision: 0x02 Driver: "ipw3945" Driver Modules: "ipw3945" Device File: eth1 Features: WLAN Memory Range: 0xdf6ff000-0xdf6fffff (rw,non-prefetchable) IRQ: 17 (no events) HW Address: 00:1c:bf:3d:22:8a Link detected: no WLAN channels: 1 2 3 4 5 6 7 8 9 10 11 12 13 34 36 38 40 42 44 46 48 52 56 60 64 100 104 108 112 116 120 124 WLAN frequencies: 2.412 2.417 2.422 2.427 2.432 2.437 2.442 2.447 2.452 2.457 2.462 2.467 2.472 5.17 5.18 5.19 5.2 5.21 5.22 5.23 5.24 5.26 5.28 5.3 5.32 5.5 5.52 5.54 5.56 5.58 5.6 5.62 WLAN bitrates: 1 2 5.5 11 6 9 12 18 24 36 48 54 WLAN encryption modes: WEP40 WEP104 TKIP CCMP WLAN authentication modes: open sharedkey wpa-psk wpa-eap Module Alias: "pci:v00008086d00004227sv00008086sd00001011bc02sc80i00" Driver Info #0: Driver Status: iwl3945 is not active Driver Activation Cmd: "modprobe iwl3945" Driver Info #1: Driver Status: ipw3945 is active Driver Activation Cmd: "modprobe ipw3945" Config Status: cfg=no, avail=yes, need=no, active=unknown Attached to: #9 (PCI bridge) -------------------- Wenn ich den Laptop starte und das eth0 device (wired network) angeschlossen ist, habe ich nach dem login eine Netzwerverbindung. Man kann dann ueber den KNetworkManager ein "Connect to Other Wireless Network" starten, die ESSID eingeben und das eth0 device wird deaktiviert und das eth1 kann sich mit dem AccessPoint verbinden ! Toll Breche ich die wireless Verbindung ab startet der NetWorker wieder die eth0 Verbindung ! Tolltoll Jeder weitere Versuch nocheinmal die Wireless Verbindung zu aktivieren scheitert :-( /var/log/NetworkManager --------- NetworkManager: <debug> [1201076162.332217] nm_device_802_11_wireless_get_activation_ap(): Forcing AP ' XXXXXXX' User Switch: /org/freedesktop/NetworkManager/Devices/eth1 / XXXXXX Deactivating device eth1. NetworkManager: <info> Device eth1 activation scheduled... NetworkManager: <info> Deactivating device eth0. NetworkManager: <info> Activation (eth1) started... NetworkManager: <info> Activation (eth1) Stage 1 of 5 (Device Prepare) scheduled... NetworkManager: <info> Activation (eth1) Stage 1 of 5 (Device Prepare) started... NetworkManager: <info> Activation (eth1) Stage 2 of 5 (Device Configure) scheduled... NetworkManager: <info> Activation (eth1) Stage 1 of 5 (Device Prepare) complete. NetworkManager: <info> Activation (eth1) Stage 2 of 5 (Device Configure) starting... NetworkManager: <info> Activation (eth1/wireless): access point 'XXXXXX' is unencrypted, no key needed. NetworkManager: <info> SUP: sending command 'INTERFACE_ADD eth1 wext /var/run/wpa_supplicant ' NetworkManager: <info> SUP: response was 'OK' NetworkManager: <info> SUP: sending command 'AP_SCAN 1' NetworkManager: <info> SUP: response was 'OK' NetworkManager: <info> SUP: sending command 'ADD_NETWORK' NetworkManager: <info> SUP: response was '0' NetworkManager:<info> SUP: sending command 'SET_NETWORK 0 ssid 69666d2d67656f6d61722d6775657374' NetworkManager: <info> SUP: response was 'OK' NetworkManager: <info> SUP: sending command 'SET_NETWORK 0 scan_ssid 1' NetworkManager: <info> SUP: response was 'OK' NetworkManager: <info> SUP: sending command 'SET_NETWORK 0 key_mgmt NONE' NetworkManager: <info> SUP: response was 'OK' NetworkManager: <info> SUP: sending command 'ENABLE_NETWORK 0' NetworkManager: <info> SUP: response was 'OK' NetworkManager: <info> Activation (eth1) Stage 2 of 5 (Device Configure) complete. NetworkManager: <info> Activation (eth1/wireless): association took too long (>60s), failing activation. NetworkManager: <info> Activation (eth1) failure scheduled... NetworkManager: <info> Activation (eth1) failed for access point (ifm-geomar-guest) NetworkManager: <info> Activation (eth1) failed. NetworkManager: <info> Deactivating device eth1. NetworkManager: <info> SWITCH: no current connection, found better connection 'eth0'. NetworkManager: <info> Will activate connection 'eth0'. ----------------------------- So sieht es aus .............. Gruss , Kai -- Um die Liste abzubestellen, schicken Sie eine Mail an: opensuse-de+unsubscribe@opensuse.org Um eine Liste aller verfuegbaren Kommandos zu bekommen, schicken Sie eine Mail an: opensuse-de+help@opensuse.org