Am Sonntag, 13. März 2005 16:06 schrieb Guido Pinkernell:
Am Sonntag, 13. März 2005 15:35 schrieb Guido Pinkernell:
sda: unknown partition table Attached scsi removable disk sda at scsi4, channel 0, id 0, lun 0 Attached scsi generic sg0 at scsi4, channel 0, id 0, lun 0, type 0 USB Mass Storage device found at 10
Wie man sieht, wird die Partitionstabelle nicht erkannt. Trotzdem kann ich ja per Hand mounten. Vielleicht liegt das ganze Problem ja in dieser Fehlermeldung begründet.
Ich habe jetzt mal meinen anderen Stick versucht. Die dmesg sieht so aus:
Die Fehlermeldungen scheinen wohl daher zu rühren. Nur: Das Adminhandbuch zu 9.2 sagt, dass für udev solche Nodes gar nicht existieren müssen. Die werden von udev ja selbst angelegt. Nach meiner udev-Regel werden die notwendigen Nodes aber mit einem anderen Namen angelegt. Und diese Nodes werden vom System wohl komplett ignoriert.
Muss ich denn udev noch irgendwo im System anmelden?
Ich gebs auf. Habe in der Hotplug config das manuelle Mounten über die fstab eingerichtet. Udev kreiert mir weiterhin die nötigen eindeutigen Device nodes, die in der fstab verwendet werden. Also Schluss mit Reinstecken und loslegen. Was mich an dem manuellen Vorgehen stört - ist aber wohl nicht zu ändern - ist, fürs Mounten und Umouten immer eine Konsole zu öffnen, sich als su anzumelden und ggf auch noch den Mountpoint des Geräts, was ich da abziehen will (und dergleichen gibts bei meinem Subnotebook ziemlich viele und das ziemlich häufig), rauszusuchen. Und dann heisst es häufig noch in einer Fehlermeldung, dass das betreffende Gerät auf dem Mountpoint noch benutzt wird, während ich doch sämtliche Programme, die ich auf dem Desktop laufen hatte, gestoppt habe. Najut. Guido