openSUSE Recommended Update: Recommended update for saptune ______________________________________________________________________________ Announcement ID: openSUSE-RU-2022:0220-1 Rating: important References: #1192029 #1192697 #1193241 #1193435 #1193576 #1193580 #1194299 #1194334 Affected Products: openSUSE Leap 15.3 ______________________________________________________________________________ An update that has 8 recommended fixes can now be installed. Description: This update for saptune fixes the following issues: - Fix LVM slave devices not to be excluded when they are valid block devices (bsc#1194299) - Fix 'not compliant' state for energy_perf_bias on PowerPC systems and suppress misleading error message regarding missing 'mokutil' (bsc#1193435) - Remove the dependency to 'mokutil' by relying on sysfs to detect a secure boot environment (bsc#1193435) - Fix problem with command `saptune revert all`, if the saptune service was stopped between the two commands `apply` and `revert all` - Fix `saptune service enablestart|disablestop` to always perform both actions and no longer stop working, if the service is already started|stopped (bsc#1193241) - Fix support support for AWS x1e instances (bsc#1192029) - Support /etc/fstab entries with 4 instead of 6 fields and change error handling from 'panic' to error log messages (bsc#1193580) - Enhance documentation in man page 'saptune.8' with the entry 'configured Note' and some more descriptions of the entries from `saptune service status` (bsc#1192697) - Fix block device settings (e.g. NRREQ) for multipath devices (bsc#1193576) - Fix `saptune verify` command to report a non existing sysctl or sys parameter as 'not available on the system'. An additional warning is displayed to raise attention to typos in the parameter name. - Fix `saptune status` command to accurately report the unit state (bsc#1194334) - Added a hint to the man page and some additional log messages as the PowerPC systems (hardware architecture 'ppc64le') don't support files in '/sys/class/dmi' Patch Instructions: To install this openSUSE Recommended Update use the SUSE recommended installation methods like YaST online_update or "zypper patch". Alternatively you can run the command listed for your product: - openSUSE Leap 15.3: zypper in -t patch openSUSE-SLE-15.3-2022-220=1 Package List: - openSUSE Leap 15.3 (ppc64le x86_64): saptune-3.0.2-8.22.2 saptune-debuginfo-3.0.2-8.22.2 References: https://bugzilla.suse.com/1192029 https://bugzilla.suse.com/1192697 https://bugzilla.suse.com/1193241 https://bugzilla.suse.com/1193435 https://bugzilla.suse.com/1193576 https://bugzilla.suse.com/1193580 https://bugzilla.suse.com/1194299 https://bugzilla.suse.com/1194334