Il 13/01/20 05:25, Jörn Dreyer ha scritto:
Hello,
since today's update I'm no longer able to connect to my office network using a copper link. NetworkManager tries to connect, but fails. The only message I see in the dmesg output is:
e1000e: enp0s25 NIC Link is Up 1000 Mbps Full Duplex, Flow Control: Rx/Tx
The wireless connection instead works. How to tackle that?
Regards,
Jörn Dreyer
The Ethernet message just demonstrates that your NIC is connected to a port where are presents electrical signals but this doesn't mean that from that point over there is a working network. Then you must troubleshoot your network step by step from the UTP cable on. If everything looks normally try to reboot your switch/routers/cable-modem, sometimes something hangs. Regards, -- Marco Calistri Build: openSUSE Tumbleweed 20200111 Kernel: 5.4.7-1-default - Cinnamon 3.8.9 -- To unsubscribe, e-mail: opensuse-support+unsubscribe@opensuse.org To contact the owner, e-mail: opensuse-support+owner@opensuse.org