lm-sensors and the setup including the new directory is installed and working. I had to reinstall my TW, before all worked error free. But now, no plasmoid seems to "see" the sensors. When I however go to CLI and do as normal user: entropy@silversurfer:~> sensors fam15h_power-pci-00c4 Adapter: PCI adapter power1: 60.33 W (crit = 95.06 W) amdgpu-pci-0300 Adapter: PCI adapter vddgfx: 6.00 mV fan1: 2300 RPM (min = 0 RPM, max = 5400 RPM) edge: +59.0°C (crit = +110.0°C, hyst = -273.1°C) (emerg = +115.0°C) junction: +60.0°C (crit = +105.0°C, hyst = -273.1°C) (emerg = +110.0°C) mem: +0.0°C (crit = +105.0°C, hyst = -273.1°C) (emerg = +110.0°C) slowPPT: 14.00 W (cap = 105.00 W) it8728-isa-0228 Adapter: ISA adapter in0: 1.20 V (min = +0.00 V, max = +3.06 V) in1: 1.49 V (min = +0.00 V, max = +3.06 V) in2: 2.02 V (min = +0.00 V, max = +3.06 V) in3: 1.97 V (min = +0.00 V, max = +3.06 V) in4: 1.96 V (min = +0.00 V, max = +3.06 V) in5: 660.00 mV (min = +0.00 V, max = +3.06 V) in6: 2.22 V (min = +0.00 V, max = +3.06 V) 3VSB: 3.29 V (min = +0.00 V, max = +6.12 V) Vbat: 3.14 V fan1: 992 RPM (min = 10 RPM) fan2: 1057 RPM (min = 0 RPM) fan3: 0 RPM (min = 0 RPM) fan4: 0 RPM (min = 0 RPM) fan5: 0 RPM (min = 0 RPM) temp1: +48.0°C (low = +127.0°C, high = +127.0°C) sensor = thermistor temp2: +50.0°C (low = +127.0°C, high = +127.0°C) sensor = thermal diode temp3: +27.0°C (low = +0.0°C, high = +90.0°C) sensor = Intel PECI intrusion0: ALARM k10temp-pci-00c3 Adapter: PCI adapter temp1: +27.4°C (high = +70.0°C) (crit = +80.0°C, hyst = +77.0°C) Three fans as expected (cpu and 2 PWR system ones) All sensors are there, but none is seen. Could this be a permissions issue? Any hint why the plasmoids do not have access to the existing values of lm- sensors? I have also reinstalled all sensor related plasmoid from the web again, but nothing, included reboot. Thankful for some clue about this. Again: ANY sensor is seen of the above in plasma.