On 17/02/2021 06.25, Doug McGarrett wrote:
On 2/16/21 4:35 PM, Carlos E.R. wrote:
On 16/02/2021 22.31, Doug McGarrett wrote:
/snip/
I would welcome some advice as to what to do at this point to get both printers working properly again, even if it is to wipe out all present configurations and start the printer setup from scratch, which I suspect might be the only logical answer. Well, explain the current symptoms when you try to print. lpq says each printer "is not ready" lpstat -r shows the scheduler is running
If it would be better to remove the printers and start this part of the system over, what is the best way to do that? If not, when what?
Common, you know the drill. Run all these commands: lpstat -a lpstat -s lpstat -t lpstat -r and paste the result here. Don't describe what the commands say, paste it all here. And this goes for every Linux problem: paste commands used and results that show the problems, in a single sweep of the mouse. -- Cheers / Saludos, Carlos E. R. (from 15.2 x86_64 at Telcontar)