Hey
After I intalled the kernel update k_atlon-2.4.19-167 I got following
message during the bootprocess :
Starting Firewall Initialization (phase 2 of 3)
<notice>'/etc/init.d/rc5.d/S07hotplug start' exits with status 0
<notice>/etc/init.d/rc5.d/S09SuSEfirewall2_setup start
<notice>pidofproc: ipppd 524
/etc/init.d/rc5.d/S09SuSEfirewall2_setup: line 74: 735 Killed
$SUSEFWALL start >/dev/null 2>&1
failed
Any Ideas ?
Frendly Regards
Kai
PS : MY /etc/init.d/rc5.d/S09SuSEfirewall2_setup :
#! /bin/sh
# Copyright (c) 2000-2002 SuSE GmbH Nuernberg, Germany.
#
# Author: Marc Heuse
#
# /etc/init.d/SuSEfirewall2_setup
#
### BEGIN INIT INFO
# Provides: SuSEfirewall2_setup
# Required-Start: SuSEfirewall2_init $network $local_fs
# X-UnitedLinux-Should-Start: route dhclient
# Required-Stop: $local_fs
# X-UnitedLinux-Should-Stop:
# Default-Start: 3 4 5
# Default-Stop: 0 1 2 6
# Short-Description: SuSEfirewall2 phase 2
# Description: SuSEfirewall2_setup does some basic setup and is the
# phase 2 of 3 of the SuSEfirewall initialization.
### END INIT INFO
# X-SuSE-Dep-Only
SUSEFWALL="/sbin/SuSEfirewall2"
test -x $SUSEFWALL || exit 5
test -r /etc/sysconfig/SuSEfirewall2 || exit 6
. /etc/rc.status
rc_reset
case "$1" in
start)
echo -n "Starting Firewall Initialization "
echo -n '(phase 2 of 3) '
$SUSEFWALL start > /dev/null 2>&1
rc_status -v
;;
stop)
echo -n "Shutting down the Firewall "
test "$FW_STOP_KEEP_ROUTING_STATE" = "yes" || echo -n "(and
disabling routing) "
$SUSEFWALL stop > /dev/null 2>&1
rc_status -v
;;
restart|force-reload)
$0 start
rc_status
;;
try-restart|reload)
($0 status) >/dev/null 2>&1 || exit 7
$0 start
rc_status
;;
restart2)
# the restart2 argument is used by yast2 to not open any ports
# while the filter rules are being rewritten.
RLVL=`/sbin/runlevel | sed 's/. //'`
if [ ! -e /etc/init.d/rc${RLVL}.d/S??SuSEfirewall2_setup ]; then
$SUSEFWALL stop > /dev/null 2>&1
fi
$SUSEFWALL start > /dev/null 2>&1
;;
long-status)
echo "Checking the status of SuSEfirewall2 "
$SUSEFWALL status || rc_failed 3
;;
status)
echo -n "Checking the status of SuSEfirewall2 "
iptables -L reject_func >/dev/null 2>&1 || rc_failed 3
rc_status -v
;;
*)
echo "Usage: $0 {start|stop|status|restart|reload|force-reload}"
exit 1
;;
esac
# Set exit status
rc_exit