[opensuse-security-announce] openSUSE-SU-2020:2053-1: moderate: Security update for wpa_supplicant
openSUSE Security Update: Security update for wpa_supplicant ______________________________________________________________________________ Announcement ID: openSUSE-SU-2020:2053-1 Rating: moderate References: #1131644 #1131868 #1131870 #1131871 #1131872 #1131874 #1133640 #1144443 #1150934 #1156920 #1166933 #1167331 #930077 #930078 #930079 Cross-References: CVE-2015-4141 CVE-2015-4142 CVE-2015-4143 CVE-2015-8041 CVE-2017-13077 CVE-2017-13078 CVE-2017-13079 CVE-2017-13080 CVE-2017-13081 CVE-2017-13082 CVE-2017-13086 CVE-2017-13087 CVE-2017-13088 CVE-2018-14526 CVE-2019-11555 CVE-2019-13377 CVE-2019-16275 CVE-2019-9494 CVE-2019-9495 CVE-2019-9497 CVE-2019-9498 CVE-2019-9499 Affected Products: openSUSE Leap 15.1 ______________________________________________________________________________ An update that fixes 22 vulnerabilities is now available. Description: This update for wpa_supplicant fixes the following issues: Security issue fixed: - CVE-2019-16275: Fixed an AP mode PMF disconnection protection bypass (bsc#1150934). Non-security issues fixed: - Enable SAE support (jsc#SLE-14992). - Limit P2P_DEVICE name to appropriate ifname size. - Fix wicked wlan (bsc#1156920) - Restore fi.epitest.hostap.WPASupplicant.service (bsc#1167331) - With v2.9 fi.epitest.hostap.WPASupplicant.service is obsolete (bsc#1167331) - Fix WLAN config on boot with wicked. (bsc#1166933) - Update to 2.9 release: * SAE changes - disable use of groups using Brainpool curves - improved protection against side channel attacks [https://w1.fi/security/2019-6/] * EAP-pwd changes - disable use of groups using Brainpool curves - allow the set of groups to be configured (eap_pwd_groups) - improved protection against side channel attacks [https://w1.fi/security/2019-6/] * fixed FT-EAP initial mobility domain association using PMKSA caching (disabled by default for backwards compatibility; can be enabled with ft_eap_pmksa_caching=1) * fixed a regression in OpenSSL 1.1+ engine loading * added validation of RSNE in (Re)Association Response frames * fixed DPP bootstrapping URI parser of channel list * extended EAP-SIM/AKA fast re-authentication to allow use with FILS * extended ca_cert_blob to support PEM format * improved robustness of P2P Action frame scheduling * added support for EAP-SIM/AKA using anonymous@realm identity * fixed Hotspot 2.0 credential selection based on roaming consortium to ignore credentials without a specific EAP method * added experimental support for EAP-TEAP peer (RFC 7170) * added experimental support for EAP-TLS peer with TLS v1.3 * fixed a regression in WMM parameter configuration for a TDLS peer * fixed a regression in operation with drivers that offload 802.1X 4-way handshake * fixed an ECDH operation corner case with OpenSSL * SAE changes - added support for SAE Password Identifier - changed default configuration to enable only groups 19, 20, 21 (i.e., disable groups 25 and 26) and disable all unsuitable groups completely based on REVmd changes - do not regenerate PWE unnecessarily when the AP uses the anti-clogging token mechanisms - fixed some association cases where both SAE and FT-SAE were enabled on both the station and the selected AP - started to prefer FT-SAE over SAE AKM if both are enabled - started to prefer FT-SAE over FT-PSK if both are enabled - fixed FT-SAE when SAE PMKSA caching is used - reject use of unsuitable groups based on new implementation guidance in REVmd (allow only FFC groups with prime >= 3072 bits and ECC groups with prime >= 256) - minimize timing and memory use differences in PWE derivation [https://w1.fi/security/2019-1/] (CVE-2019-9494, bsc#1131868) * EAP-pwd changes - minimize timing and memory use differences in PWE derivation [https://w1.fi/security/2019-2/] (CVE-2019-9495, bsc#1131870) - verify server scalar/element [https://w1.fi/security/2019-4/] (CVE-2019-9497, CVE-2019-9498, CVE-2019-9499, bsc#1131874, bsc#1131872, bsc#1131871, bsc#1131644) - fix message reassembly issue with unexpected fragment [https://w1.fi/security/2019-5/] (CVE-2019-11555, bsc#1133640) - enforce rand,mask generation rules more strictly - fix a memory leak in PWE derivation - disallow ECC groups with a prime under 256 bits (groups 25, 26, and 27) - SAE/EAP-pwd side-channel attack update [https://w1.fi/security/2019-6/] (CVE-2019-13377, bsc#1144443) * fixed CONFIG_IEEE80211R=y (FT) build without CONFIG_FILS=y * Hotspot 2.0 changes - do not indicate release number that is higher than the one AP supports - added support for release number 3 - enable PMF automatically for network profiles created from credentials * fixed OWE network profile saving * fixed DPP network profile saving * added support for RSN operating channel validation (CONFIG_OCV=y and network profile parameter ocv=1) * added Multi-AP backhaul STA support * fixed build with LibreSSL * number of MKA/MACsec fixes and extensions * extended domain_match and domain_suffix_match to allow list of values * fixed dNSName matching in domain_match and domain_suffix_match when using wolfSSL * started to prefer FT-EAP-SHA384 over WPA-EAP-SUITE-B-192 AKM if both are enabled * extended nl80211 Connect and external authentication to support SAE, FT-SAE, FT-EAP-SHA384 * fixed KEK2 derivation for FILS+FT * extended client_cert file to allow loading of a chain of PEM encoded certificates * extended beacon reporting functionality * extended D-Bus interface with number of new properties * fixed a regression in FT-over-DS with mac80211-based drivers * OpenSSL: allow systemwide policies to be overridden * extended driver flags indication for separate 802.1X and PSK 4-way handshake offload capability * added support for random P2P Device/Interface Address use * extended PEAP to derive EMSK to enable use with ERP/FILS * extended WPS to allow SAE configuration to be added automatically for PSK (wps_cred_add_sae=1) * removed support for the old D-Bus interface (CONFIG_CTRL_IFACE_DBUS) * extended domain_match and domain_suffix_match to allow list of values * added a RSN workaround for misbehaving PMF APs that advertise IGTK/BIP KeyID using incorrect byte order * fixed PTK rekeying with FILS and FT * fixed WPA packet number reuse with replayed messages and key reinstallation [https://w1.fi/security/2017-1/] (CVE-2017-13077, CVE-2017-13078, CVE-2017-13079, CVE-2017-13080, CVE-2017-13081, CVE-2017-13082, CVE-2017-13086, CVE-2017-13087, CVE-2017-13088) * fixed unauthenticated EAPOL-Key decryption in wpa_supplicant [https://w1.fi/security/2018-1/] (CVE-2018-14526) * added support for FILS (IEEE 802.11ai) shared key authentication * added support for OWE (Opportunistic Wireless Encryption, RFC 8110; and transition mode defined by WFA) * added support for DPP (Wi-Fi Device Provisioning Protocol) * added support for RSA 3k key case with Suite B 192-bit level * fixed Suite B PMKSA caching not to update PMKID during each 4-way handshake * fixed EAP-pwd pre-processing with PasswordHashHash * added EAP-pwd client support for salted passwords * fixed a regression in TDLS prohibited bit validation * started to use estimated throughput to avoid undesired signal strength based roaming decision * MACsec/MKA: - new macsec_linux driver interface support for the Linux kernel macsec module - number of fixes and extensions * added support for external persistent storage of PMKSA cache (PMKSA_GET/PMKSA_ADD control interface commands; and MESH_PMKSA_GET/MESH_PMKSA_SET for the mesh case) * fixed mesh channel configuration pri/sec switch case * added support for beacon report * large number of other fixes, cleanup, and extensions * added support for randomizing local address for GAS queries (gas_rand_mac_addr parameter) * fixed EAP-SIM/AKA/AKA' ext auth cases within TLS tunnel * added option for using random WPS UUID (auto_uuid=1) * added SHA256-hash support for OCSP certificate matching * fixed EAP-AKA' to add AT_KDF into Synchronization-Failure * fixed a regression in RSN pre-authentication candidate selection * added option to configure allowed group management cipher suites (group_mgmt network profile parameter) * removed all PeerKey functionality * fixed nl80211 AP and mesh mode configuration regression with Linux 4.15 and newer * added ap_isolate configuration option for AP mode * added support for nl80211 to offload 4-way handshake into the driver * added support for using wolfSSL cryptographic library * SAE - added support for configuring SAE password separately of the WPA2 PSK/passphrase - fixed PTK and EAPOL-Key integrity and key-wrap algorithm selection for SAE; note: this is not backwards compatible, i.e., both the AP and station side implementations will need to be update at the same time to maintain interoperability - added support for Password Identifier - fixed FT-SAE PMKID matching * Hotspot 2.0 - added support for fetching of Operator Icon Metadata ANQP-element - added support for Roaming Consortium Selection element - added support for Terms and Conditions - added support for OSEN connection in a shared RSN BSS - added support for fetching Venue URL information * added support for using OpenSSL 1.1.1 * FT - disabled PMKSA caching with FT since it is not fully functional - added support for SHA384 based AKM - added support for BIP ciphers BIP-CMAC-256, BIP-GMAC-128, BIP-GMAC-256 in addition to previously supported BIP-CMAC-128 - fixed additional IE inclusion in Reassociation Request frame when using FT protocol - Changed service-files for start after network (systemd-networkd). This update was imported from the SUSE:SLE-15:Update update project. Patch Instructions: To install this openSUSE Security Update use the SUSE recommended installation methods like YaST online_update or "zypper patch". Alternatively you can run the command listed for your product: - openSUSE Leap 15.1: zypper in -t patch openSUSE-2020-2053=1 Package List: - openSUSE Leap 15.1 (i586 x86_64): wpa_supplicant-2.9-lp151.5.10.1 wpa_supplicant-debuginfo-2.9-lp151.5.10.1 wpa_supplicant-debugsource-2.9-lp151.5.10.1 wpa_supplicant-gui-2.9-lp151.5.10.1 wpa_supplicant-gui-debuginfo-2.9-lp151.5.10.1 References: https://www.suse.com/security/cve/CVE-2015-4141.html https://www.suse.com/security/cve/CVE-2015-4142.html https://www.suse.com/security/cve/CVE-2015-4143.html https://www.suse.com/security/cve/CVE-2015-8041.html https://www.suse.com/security/cve/CVE-2017-13077.html https://www.suse.com/security/cve/CVE-2017-13078.html https://www.suse.com/security/cve/CVE-2017-13079.html https://www.suse.com/security/cve/CVE-2017-13080.html https://www.suse.com/security/cve/CVE-2017-13081.html https://www.suse.com/security/cve/CVE-2017-13082.html https://www.suse.com/security/cve/CVE-2017-13086.html https://www.suse.com/security/cve/CVE-2017-13087.html https://www.suse.com/security/cve/CVE-2017-13088.html https://www.suse.com/security/cve/CVE-2018-14526.html https://www.suse.com/security/cve/CVE-2019-11555.html https://www.suse.com/security/cve/CVE-2019-13377.html https://www.suse.com/security/cve/CVE-2019-16275.html https://www.suse.com/security/cve/CVE-2019-9494.html https://www.suse.com/security/cve/CVE-2019-9495.html https://www.suse.com/security/cve/CVE-2019-9497.html https://www.suse.com/security/cve/CVE-2019-9498.html https://www.suse.com/security/cve/CVE-2019-9499.html https://bugzilla.suse.com/1131644 https://bugzilla.suse.com/1131868 https://bugzilla.suse.com/1131870 https://bugzilla.suse.com/1131871 https://bugzilla.suse.com/1131872 https://bugzilla.suse.com/1131874 https://bugzilla.suse.com/1133640 https://bugzilla.suse.com/1144443 https://bugzilla.suse.com/1150934 https://bugzilla.suse.com/1156920 https://bugzilla.suse.com/1166933 https://bugzilla.suse.com/1167331 https://bugzilla.suse.com/930077 https://bugzilla.suse.com/930078 https://bugzilla.suse.com/930079
participants (1)
-
opensuse-security@opensuse.org