![](https://seccdn.libravatar.org/avatar/4ca3f0091a6f5d84813e4a712d774671.jpg?s=120&d=mm&r=g)
On Thu, Oct 18, 2007 at 02:17:42AM +0200, Mark Struberg wrote:
Hi!
My X1300 pro had problems with my DVI attached monitor since LVTMA currently only uses LVDS signal.
This patch will now enable TMDS if a DVI connector is beeing detected. The main difference is the
RHDRegWrite(Output, LVTMA_MODE, lvtmaMode); where 0=LVDS, 1=TMDS.
I hope this also works for others which previously got the message "RHDLVTMAInit: unhandled connector type: 2". If not, please be patient with me since I'm completely new to X driver programming :) So I guess there are still many things to do for making TMDS support complete (like 24bit handling), but hope it's at least a starting point.
LieGr?, strub
Mark, This is rather horrible. TMDS requires a rather different setup of this block entirely, and by just shifting some identifiers and some state tracking around, you are not implementing actual TMDS, you just toggle the one bit, but continue setting up everything else like LVDS. I am actually amazed that you didn't see any issues with using this code. It speaks for the hardware that it is this resilient. Please refrain from pulling these things, it only encourages others to try this, which might lead to damaging their hardware. Do have a bit of patience, i will dive into this as soon as the PLL boundaries are mapped and properly implemented. Luc Verhaegen. SUSE/Novell X Driver Developer. -- To unsubscribe, e-mail: radeonhd+unsubscribe@opensuse.org For additional commands, e-mail: radeonhd+help@opensuse.org