Hello there, I tried the actual git radeonhd today with my x1300 and perhaps you are interested in the xorg log file. It does not work. See the xorg log attached. I can't read so much in those error messages. Thanks for your work! Regards Paul. # lspci -vv | grep ATI -A 18 02:00.0 VGA compatible controller: ATI Technologies Inc RV515 [Radeon X1300] (prog-if 00 [VGA]) Subsystem: Hightech Information System Ltd. Unknown device 2158 Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B- Status: Cap+ 66MHz+ UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR- <PERR- Latency: 32 (2000ns min), Cache Line Size: 32 bytes Interrupt: pin A routed to IRQ 12 Region 0: Memory at d0000000 (32-bit, prefetchable) [size=256M] Region 1: I/O ports at a000 [size=256] Region 2: Memory at e9000000 (32-bit, non-prefetchable) [size=64K] [virtual] Expansion ROM at e8000000 [disabled] [size=128K] Capabilities: [50] Power Management version 2 Flags: PMEClk- DSI- D1+ D2+ AuxCurrent=0mA PME(D0-,D1-,D2-,D3hot-,D3cold-) Status: D0 PME-Enable- DSel=0 DScale=0 PME- Capabilities: [58] AGP version 3.0 Status: RQ=256 Iso- ArqSz=0 Cal=0 SBA+ ITACoh- GART64- HTrans- 64bit- FW+ AGP3+ Rate=x4,x8 Command: RQ=1 ArqSz=0 Cal=0 SBA+ AGP- GART64- 64bit- FW- Rate=<none> Capabilities: [80] Message Signalled Interrupts: Mask- 64bit+ Queue=0/0 Enable- Address: 0000000000000000 Data: 0000 02:00.1 Display controller: ATI Technologies Inc RV515 [Radeon X1300] (Secondary) Subsystem: Hightech Information System Ltd. Unknown device 2159 Control: I/O- Mem- BusMaster- SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B- Status: Cap+ 66MHz+ UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR- <PERR- Region 0: Memory at e9010000 (32-bit, non-prefetchable) [disabled] [size=64K] Capabilities: [50] Power Management version 2 Flags: PMEClk- DSI- D1+ D2+ AuxCurrent=0mA PME(D0-,D1-,D2-,D3hot-,D3cold-) Status: D0 PME-Enable- DSel=0 DScale=0 PME-