On Sat, Jun 21, 2008 at 12:56 PM, Alberto Barradas <ajcb@rocketmail.com> wrote:

1)I boot the installer(11.0) from a harddrive partition(hfsplus) and the installation system is downloaded from an opensuse

Not sure what you mean. When the installation system is downloaded, it's being loaded into ram. It has a 4 part thing. Once that is done, the installation starts.

2)I have 160MB memory,so is it safe to use X based 11.0 installer or would be better to use : install textmode=1 at the install boot prompt?

If you have less than 256MB RAM, you will need to setup a swap partition first, or the installer will probably fail. Also, please list you system specs. Since you say you have 160MB, I assume you are using a PCI PowerMac(Beige) or a Beige G3? I also sent this message to the opensuse-ppc list, which is a better place for you to get answers on PPC hardware related questions. You can subscribe to it by sending a message to this address: opensuse-ppc+subscribe@opensuse.org --------------------------------------------------------------------- To unsubscribe, e-mail: opensuse-ppc+unsubscribe@opensuse.org For additional commands, e-mail: opensuse-ppc+help@opensuse.org