How do you do. My Name is Hiroyuki Masuda. I am Japanese. I installed "OpenSUSE 10.1 alpha 2" in the notebook PC (It's Products name "Fujitsu FMV BIBLO MG13DP") . The easy report is as follows. ################ - Time which installation took : 110 minutes [ about ] . - USB-HDD Automatic　Mount : Success. Device Name = /dev/sda1 . Vendor = IC25N020 Model: ATMR04-0 . Mount Point Name = /media/USBDISK . - CD-ROM Automatic　Mount : Success. Device Name = /dev/hdc1 . Vendor = MATSHITADVD-RAM UJ-811, ATAPI CD/DVD-ROM drive Mount Point Name = /media/dvdram . - Automatic recognition of a network card : NG . I set up manually by "yast2" . Ssh communication was completed between this PC and other PCs. Driver Module Name = 8139too Device Name = eth0 - Automatic recognition of a video card : NG . yast2 cannot carry out automatic recognition of the video card on PC "Fujitsu FMV BIBLO MG13DP.". - Automatic X configuration : NG SaX2 became an error. The contents of an error are as follows. "Could not open file: /usr/share/sax/pr ...... at /usr/share/sax/modules/SPPParse.pm line 61." It was the same result as both KDE and NOME. ################### Again, if some useful information is acquired, I will make contact. See you.