Hallo zusammen ich habe 3 avi Filme von einem neuen Cannon Foto mit transcode nach MPEG2 gewandelt, diese in Projekt X in eine Datei demultiplext und mit mplex dann daaraus eine mpg Datei gemacht. Nun moechte ich das Ergebnis in Project X schneiden, aber wenn ich die '|>' oder '>>' oder '>>>' Tasten benutzen will, sage er mir nur error while decoding frame not enough data in buffer Kann jemand was damit anfangen und hat auch noch eine Loesung ? An den Einstellungen von PX habe ich schon lange nichts mehr veraendert. Diese haben bisher mit den aelteren PX Versionen gepasst. Version: ProjectX-0.90.4.00-0.pm.0 suse 10.1 32bit Gruesse Werner Franke PS: Das ist meine erste Mail an die Listen nach meiner Zwangsumstellung nach MR Outlook. Sorry, falls die mail nicht so ganz OK ist.
Hi, 0n 06/07/14@10:40 FRANKE, WERNER (Werner) told me:
ich habe 3 avi Filme von einem neuen Cannon Foto mit transcode nach
Du hast mit einer Canon Digicam einen Film aufgenommen? Da musst Du sehr vorsichtig sein, die Dinger liefern AFAIK mjpeg (irgendwas bei 15 fps) und mono pcm 8bit, 11500 Hz. Also ganz was wildes ;). Grade an dem 8bit Sound haengen sich einige transcode Versionen gern auf, so dass einem nur noch sox bleibt :(. Hast Du die transcode Zeile noch zur Hand? Was sagt tcprobe zu dem Ergebnis?
MPEG2 gewandelt, diese in Projekt X in eine Datei demultiplext und mit mplex
und die mplex Zeile?
dann daaraus eine mpg Datei gemacht.
... und was sagt tcprobe dann dazu? -- bye maik
participants (2)
-
FRANKE, WERNER (Werner)
-
Maik Holtkamp