Druckeranschluss und modprobe.conf
Hallo! Auf meinem Toshiba Sat läuft der Drucker nicht (Suse 9.1), weil, so die Fehlermeldung, die paral. Schnittstelle nicht richtig konfiguriert ist. Ich vermute, dass es daran liegt, dass in /etc/modprobe.conf die beiden Zeilen noch kommentiert sind, die für die Verwendung einer paral. Schnittstelle notwendig sind (siehe unten). Erste Frage: kann es tatsächlich daran liegen und ich muss die beiden Zeilen entkommentieren. Zweite Frage: Wenn ja, wie finde ich heraus, was ich für "frpw" eintragen soll? Danke im voraus Salvatore ######################################################################## # For parallel port devices, uncomment the following two lines and # change "frpw" to the protocol type you use ######################################################################## # install paride /sbin/modprobe --ignore-install paride && { /sbin/modprobe --ignore-install frpw; } # remove paride { /sbin/modprobe -r --ignore-remove frpw; } ; /sbin/modprobe -r --ignore-remove paride
On Thu, 12 Aug 2004 17:04:25 +0200
Salvatore Barbaro
# install paride /sbin/modprobe --ignore-install paride && { /sbin/modprobe --ignore-install frpw; } # remove paride { /sbin/modprobe -r --ignore-remove frpw; } ; /sbin/modprobe -r --ignore-remove paride
Hi die sind für Pararell IDE Geräten wie CDROM etc. Gruss Menuhin
participants (2)
-
Saitov Menuhin
-
Salvatore Barbaro