Am Mittwoch, 5. Mai 2004 17:46 schrieb Andreas:
Stam Nicolis wrote:
Andreas wrote:
(a) Wie stellst Du fest, dass dieser doch gut erkannt ist? Was steht bei dmesg, bzw in /var/log/messages? Gibt es, nämlich, die Zeile
sda: sda1
...
Initializing USB Mass Storage driver... usb.c: registered new driver usb-storage scsi1 : SCSI emulation for USB Mass Storage devices Vendor: LEXAR Model: JUMPDRIVE Rev: 1.30 Type: Direct-Access ANSI SCSI revision:
sieht doch sehr gut aus
02 WARNING: USB Mass Storage data integrity not assured
schon mal darüber nachgedacht, ob der nagelneue Stick überhaupt partitioniert ist?
USB Mass Storage device found at 2 USB Mass Storage support registered. Attached scsi removable disk sda at scsi1, channel 0, id 0, lun 0 SCSI device sda: 251904 512-byte hdwr sectors (129 MB) sda: Write Protect is off sda: sda1
probier mal ein fdisk /dev/sda und sieh dir die Partitionen an oder leg sie an falls keine da sind. Dann natürlich noch ein Dateisystem erstellen ... man mkfs ! ...
Hallo habe es natürlich getestet, und es ist dabei. Andreas
Dann viel Spass :-) -- MfG Rolf Masfelder EMail: rolf.masfelder@nector.de