On 21/11/2013 20:36, Gianluca Interlandi wrote:
One thing that I am confused about: you say that you used yast to change the runlevels where the haldaemon is started. However, my runlevel editor in yast shows only "B" as a runlevel option (all others, e.g., 2,3,5 are not shown). This is a common issue with openSUSE 12.3 and it is due to the switch from sysv to systemd:
http://forums.opensuse.org/english/get-technical-help-here/pre-release-beta/...
I suspect that I have mixed up the two systems. The 12.2 system was quite certainly changed using YaST as I described. I just fired up my 12.3 VB and YaST shows only that the service is running, even under expert mode, though chkconfig (OK, so I still tend to use the pre-systemd commands!) shows 2, 3 and 5 are set for it. It was some time ago now, and I know that I did experiment around that time with the systemctl commands but I don't recall using it to set haldaemon's service levels. I must be getting old... -- Chris "Chika" Johnson MMW Crashnet -- To unsubscribe, e-mail: opensuse-kde3+unsubscribe@opensuse.org To contact the owner, e-mail: opensuse-kde3+owner@opensuse.org