Re: Dynalink TAS103H ISA problems
On Thu, Oct 18, 2001 at 08:52:37PM +0200, Per Henrik Johansen wrote:
On Thu, 18 Oct 2001, Karsten Keil wrote:
IRQ 3 don't work on most motherboards (because it's fixed to serial) 10, 11, 5 and 7 are good startpoints.
I still get the "getting no interrupts" messages when trying the above IRQ's (+ a few other). To set the new IRQ, I change the setting in isapnp.conf. I hope this is the correct approach.
So, the card is loaded by isapnp, but not "recognized" by the driver.
Could the Port=0x100 have something to do with the problem?
Yes. It seems that isapnp do not work or here are conflicts.
... HiSax: Asuscom ISDNLink driver Rev. 1.11 ISDNLink: defined at 0x100 IRQ 3 ISDNLink: ISAC version (ff): 2085 V2.3 ISDNLink: HSCX version A: A2 B: A2
ISAC version (ff) and HSCX version A: A2 shows that here are is nothing read from the addresses, so the card is not there. -- Karsten Keil SuSE Labs ISDN development
participants (1)
-
Karsten Keil