Hi everybody, it's not "really" factory anymore, but I think it should work, because I don't have the problems with 12.1 and I havn't found any solution right now. I'm trying to install openSUSE 13.1 on a ThinkPad X60s (CoreDuo, Intel 950 graphics, Intel 3945ABG wifi, SanDisk 128GB SSD). The installation went through mostly fine, all hardware was detected correctly but I was not able to establish a wifi-connection during installation (shows SSIDs for available APs, but does not get an IP), so I went for cable to finish the installation including all available updates. On next reboot, it takes quite long (>60s) to go over the Grub showing the boot menu and even worse, the system is not booting into runlevel 5 at all, last message seen is "Started SuSEfirewall2 phase 2". I can change to an other console, after connecting a cable I have working network and I can start XFCE4 manually from there. Now I am also able to connect to my wifi-network, using the NetworkManager. I can get over the "Started SuSEfirewall2 phase 2" if I switch the network from NetworkManager to ipup, but then I'm not able to get a Wifi connection anymore (only SSIDs viewable, but no IP-connection). Any idea what I can check to solve this problem? I'm using 13.1, because it should be a "evergreen" version, while I was a SuSE user for long time, I stopped using it some time ago, because I was not willing to do frequent distribution upgrades, so "evergreen" seems to be a good option for me. -- kind regards, Thorolf -- To unsubscribe, e-mail: opensuse-factory+unsubscribe@opensuse.org To contact the owner, e-mail: opensuse-factory+owner@opensuse.org