can any tell me why, or is this is a Problem with YaST2.
I create with discpart a GPT Table and install Linux in UEFI Mode and run in
Problems, on second start the UEFI code is not correct written to the NVRAM?
The System is not booting?
When I check the disk after Installing, the GPT Table do not exist in diskpart
Next installation written a new GPT Table with YasT2
The NVRAM is cleared with efibootmgr, afterward
I have also a bad UEFI Entry in the NVRAM I have only 1 Entry (0000) but the
boot Order is 0001,0001,0001,0000
Sometimes after NEW Installation the UEFI Boot is possible,
but it is not longer possible to Start a other System or from DVD F10
(Startmenü) and F2 (Bios Setup) is not longer working.
When I clear the NVRAM with efibootmgr F10 / F2 is working again?
mit freundlichen Grüßen / best Regards,
Günther J. Niederwimmer
To unsubscribe, e-mail: opensuse-factory+unsubscribe(a)opensuse.org
To contact the owner, e-mail: opensuse-factory+owner(a)opensuse.org
Show replies by date