Op zaterdag 10 maart 2018 13:56:31 CET schreef Carlos E. R.:
On 2018-03-10 10:24, Frank Krüger wrote:
Am 10.03.2018 um 09:55 schrieb Per Jessen:
Carlos E. R. wrote:
How do I open the ssh port in the new firewald? There is a module in YaST, but I can not understand it at all.
When trying to run the YaST firewall module, I only got a message that
there is no module yet: See subsection "Firewalld enhancements" at Yast Development Sprint 50:
https://lizards.opensuse.org/2018/02/09/highlights-of-yast-development-spr int-50/ We need simple documentation with examples. At <https://doc.opensuse.org/>
Error YaST currently does not have a module for configuring firewall. Please, either use "firewall-config" to configure your firewall via a user interface or "firewall-cmd" for the command line.
Given the package firewall-config (and the corresponding applet, if you wish) allows you to configure almost everything. By the way, in firewalld ssh and open port 22 is enabled per default, e.g., for the home zone.
It may allow configuration, if you know how. I did not understand any of it.
Could you give us an overview of the steps you took to actually get some understanding of it, apart from popping questions here? It took me half an hour to get my firewalld instance in the same state as I had SuSEfirewall before the move to firewalld.
And it certainly did not open open port 22, and it certainly did not log anything to the firewall log or the journal.
Can you explain how to open 22?
I installed from DVD with network active.
-- Gertjan Lettink, a.k.a. Knurpht openSUSE Board Member openSUSE Forums Team Linux user #548252 -- To unsubscribe, e-mail: opensuse-factory+unsubscribe@opensuse.org To contact the owner, e-mail: opensuse-factory+owner@opensuse.org