With 10.2 alpha 5, I'm completely unable to configure X. When sax starts up, I get "out of range" error on the monitor and have to ctrl-alt-bksp. sax2 -l from the command line is unusable because not enough of the screen shows to be able to make selections. I was eventually able to get sax to run by "sax2 -V 0:1280x1024@60", but still couldn't come up with a combination that would produce any output when the test runs, even by specifying the frequencies from the monitor's spec sheet. This is with ATI RV250 card and Benq FP731 LDC monitor (which was auto-detected). Shall I file a bug, or is it a known issue? -- Glenn Holmer (Q-Link: ShadowM) http://www.lyonlabs.org/commodore/c64.html --------------------------------------------------------------------- To unsubscribe, e-mail: opensuse-factory+unsubscribe@opensuse.org For additional commands, e-mail: opensuse-factory+help@opensuse.org