Linksys PCMCIA wpc54g ver. 1.2 card. Just upgraded to 10.3 b3plus and the wireless is broken AGAIN! Worked with A5 a I recall. Upgraded to factory to see if any fixes might have taken place but no luck. I can't be the only one in the world that experiences this on a continuous basis. Now I get the following: bcm43xx driver PCI: Enabling device 0000:03:00.0 (0000 -> 0002) ACPI: PCI Interrupt 0000:03:00.0[A] -> Link [LNKD] -> GSI 10 (level, low) -> IRQ 10 PCI: Setting latency timer of device 0000:03:00.0 to 64 bcm43xx: Chip ID 0x4306, rev 0x3 bcm43xx: Number of cores: 5 bcm43xx: Core 0: ID 0x800, rev 0x4, vendor 0x4243 bcm43xx: Core 1: ID 0x812, rev 0x5, vendor 0x4243 bcm43xx: Core 2: ID 0x80d, rev 0x2, vendor 0x4243 bcm43xx: Core 3: ID 0x807, rev 0x2, vendor 0x4243 bcm43xx: Core 4: ID 0x804, rev 0x9, vendor 0x4243 bcm43xx: PHY connected bcm43xx: Detected PHY: Analog: 2, Type 2, Revision 2 bcm43xx: Detected Radio: ID: 2205017f (Manuf: 17f Ver: 2050 Rev: 2) bcm43xx: Radio turned off bcm43xx: Radio turned off Adding 787176k swap on /dev/sda2. Priority:-1 extents:1 across:787176k device-mapper: ioctl: 4.11.0-ioctl (2006-10-12) initialised: dm-devel@redhat.com loop: module loaded fuse init (API version 7.8) powernow: This module only works with AMD K7 CPUs bcm43xx: set security called, .level = 0, .enabled = 0, .encrypt = 0 ieee80211_crypt: registered algorithm 'WEP' bcm43xx: set security called, .active_key = 0, .level = 1, .enabled = 1, .encrypt = 1, .auth_mode = 0 SoftMAC: Associate: Scanning for networks first. SoftMAC: Associate: failed to initiate scan. Is device up? bcm43xx: PHY connected bcm43xx: Microcode rev 0xef, pl 0xe (2003-07-10 18:59:06) bcm43xx: Radio turned on bcm43xx: Radio enabled by hardware bcm43xx: Chip initialized bcm43xx: 30-bit DMA initialized bcm43xx: Keys cleared bcm43xx: Selected 802.11 core (phytype 2) Hopefully this can be fixed before the final release. Also, a bug report has been opened and closed numerous times on this problem. Ken --------------------------------------------------------------------- To unsubscribe, e-mail: opensuse-factory+unsubscribe@opensuse.org For additional commands, e-mail: opensuse-factory+help@opensuse.org