Hi, For a while now, it has been possible to enable/disable PulseAudio by setting the PULSEAUDIO_ENABLE variable in /etc/sysconfig/sound and by calling the setup-pulseaudio helper. However, by default, there was no such PULSEAUDIO_ENABLE variable in /etc/sysconfig/sound (fillup wasn't called), and on new installs, this setting was not propagated to various files. This resulted in no real enforcement of the PA configuration. I'm fixing this, see https://bugzilla.novell.com/show_bug.cgi?id=707703 for a small discussion. With the fix, when the pulseaudio package is installed/updated, relevant configuration files are updated based on the PULSEAUDIO_ENABLE setting. This might impact people who either had a customized sound configuration for PulseAudio (ie, PA disabled for, say, libao but enabled for alsa), or for people who had manually disabled PulseAudio with just the setup-pulseaudio helper: PULSEAUDIO_ENABLE will be set to "yes" if it's not already defined, and that will forcefully enable PA everywhere. The solution is to edit /etc/sysconfig/sound and set PULSEAUDIO_ENABLE to either "no" (which means "don't use PulseAudio") or "custom" (which means "do not touch the PulseAudio-related configuration). This should also get mentioned in release notes for 12.1. What's the best way to make sure this happens? Thanks, Vincent -- Les gens heureux ne sont pas pressés. -- To unsubscribe, e-mail: opensuse-factory+unsubscribe@opensuse.org For additional commands, e-mail: opensuse-factory+help@opensuse.org