https://bugzilla.novell.com/show_bug.cgi?id=216170 Summary: Suse does not want to load the module pata_jmicron for the jmicron jmb363 controller by default. Product: openSUSE 10.2 Version: Beta 1 Platform: x86 OS/Version: Other Status: NEW Severity: Normal Priority: P5 - None Component: Kernel AssignedTo: kernel-maintainers@forge.provo.novell.com ReportedBy: msd19@case.edu QAContact: qa@suse.de Basically suse does not load pata_jmicron by default, but can do so. For some reason it does not do so at all with brokenmodules=pata_jmicron System: Gigabyte GA-965P-S3 motherboard with a core 2 duo e6300 has a Jmicron JMB363 IDE/SATA (software raid) controller 2 serial ata hard drives on the SATA interface a hard drive and a dvd burner on the IDE interface and it has an ICH8 SATA controller with 2 drives on it using a an x86 DVD even though I could use an x86_64 one Description: During verbose startup, it lists SATA conttoller 1 IDE it lists ata_piix and generic for this and Jmicron 20360/20363 AHCI controller it lists jmicron_pata, generic, and AHCI for this Once I go into the blue linuxrc menu, it mentions that it can't find the installation DVD. I then observe the following things to suggest that the pata_jmicron module has not been loaded If I check the list of drives under system information, I see all my sata hard drives from the ICH8 under the module ata_piix. I see all my sata drives from the jmb363 under the module ahci, and I see my usb drives under usb-storage. I do not see my IDE drives from the jmb363. If I check the list of modules loaded, I do see ata_piix and ahci, but I do not see pata_jmicron If I check the kernel messages, I see lines for ahci and ata_piix, but I do not see lines for pata_jmicron If i then tell it to load the pata_jmicron module, it does so, but under kernel messages it says that it is not supported by novell, tainting U flag. I thought this was only done for ndiswrapper and proprietary modules? I can however continue with setup from this point. If I boot with brokenmodules=pata_jmicron, the module is not loaded by default, and when I go to load it, it says it fails to do so. -- Configure bugmail: https://bugzilla.novell.com/userprefs.cgi?tab=email ------- You are receiving this mail because: ------- You are on the CC list for the bug, or are watching someone who is.