http://bugzilla.suse.com/show_bug.cgi?id=1090458 http://bugzilla.suse.com/show_bug.cgi?id=1090458#c14 --- Comment #14 from Ivan Levshin <ivan.levshin@microfocus.com> --- I've been trying wyth YaST when I got those messages, finally I installed it with zypper without any problem Now WiFi seems to be running fine - I still need some time for monitoring. Right now I can say that firmware load error still here: ivan@mynote:~> dmesg|grep ath10k [ 5.571975] ath10k_pci 0000:3e:00.0: enabling device (0000 -> 0002) [ 5.572932] ath10k_pci 0000:3e:00.0: pci irq msi oper_irq_mode 2 irq_mode 0 reset_mode 0 [ 5.896645] ath10k_pci 0000:3e:00.0: Direct firmware load for ath10k/pre-cal-pci-0000:3e:00.0.bin failed with error -2 [ 5.896654] ath10k_pci 0000:3e:00.0: Direct firmware load for ath10k/cal-pci-0000:3e:00.0.bin failed with error -2 [ 5.896976] ath10k_pci 0000:3e:00.0: Direct firmware load for ath10k/QCA6174/hw2.1/firmware-6.bin failed with error -2 [ 5.900202] ath10k_pci 0000:3e:00.0: qca6174 hw2.1 target 0x05010000 chip_id 0x003405ff sub 1a56:1525 [ 5.900204] ath10k_pci 0000:3e:00.0: kconfig debug 0 debugfs 0 tracing 0 dfs 0 testmode 0 [ 5.900524] ath10k_pci 0000:3e:00.0: firmware ver SW_RM.1.1.1-00157-QCARMSWPZ-1 api 5 features ignore-otp,no-4addr-pad crc32 10bf8e08 [ 5.964525] ath10k_pci 0000:3e:00.0: board_file api 2 bmi_id N/A crc32 ae2e275a [ 7.137174] ath10k_pci 0000:3e:00.0: htt-ver 3.1 wmi-op 4 htt-op 3 cal otp max-sta 32 raw 0 hwcrypto 1 [ 7.243263] ath10k_pci 0000:3e:00.0 wlp62s0: renamed from wlan0 But WiFi seems to running fine. -- You are receiving this mail because: You are on the CC list for the bug.