https://bugzilla.suse.com/show_bug.cgi?id=1173402 https://bugzilla.suse.com/show_bug.cgi?id=1173402#c13 --- Comment #13 from Thomas Blume --- (In reply to Fabian Vogt from comment #12)

What should be done IMO:

- Touch did-setup in the "# No ip lines default to dhcp" case after successful do_dhcp - Touch did-setup in the "# no ip option directed at our interface?" case after successful do_dhcp

0b998beebc008f2dda2eed8a36d59f4a258cb27a introduced the code to handle the latter, but: - It also runs in cases where the do_dhcp in this block wasn't actually run (like in this bug report) - The $? it checks is meaningless at this point due to the ifs

In the "rd.neednet=1 bootdev=eth0" case it actually runs do_dhcp twice for the interface, as both "# No ip ..." blocks apply. Maybe those blocks should be merged?

Ok, let me investigate that. The patch from bsc#1172807 also needs more investigation, because on dual stack setups, dracut must not skip the ipv6 setup when the ipv4 setup was successfull. Will let you know as soon as I have something to try. -- You are receiving this mail because: You are on the CC list for the bug.