https://bugzilla.suse.com/show_bug.cgi?id=1217492 https://bugzilla.suse.com/show_bug.cgi?id=1217492#c18 --- Comment #18 from P <opensuse@pohw.nl> --- I'm afraid the challenges are greater than expected. The output is:

vmhost:~/Bugzilla_1217492 # ./test_libusb_get_active_config_desc LIBUSB_SUCCESS = 0 LIBUSB_ERROR_IO = -1 LIBUSB_ERROR_INVALID_PARAM = -2 LIBUSB_ERROR_ACCESS = -3 LIBUSB_ERROR_NO_DEVICE = -4 LIBUSB_ERROR_NOT_FOUND = -5 LIBUSB_ERROR_BUSY = -6 LIBUSB_ERROR_TIMEOUT = -7 LIBUSB_ERROR_OVERFLOW = -8 LIBUSB_ERROR_PIPE = -9 LIBUSB_ERROR_INTERRUPTED = -10 LIBUSB_ERROR_NO_MEM = -11 LIBUSB_ERROR_NOT_SUPPORTED = -12 LIBUSB_ERROR_OTHER = -99 rc = 0 Active Configuration: Configuration Value: 1 Number of Interfaces: 2

Just to confirm: - My vmhost is a bare minimum configuration. So I can't run development stuff on it. I set up a development vm specifically for this test. Installed from the Leap 15.5 DVD ISO, zypper update 1 hour ago. I've copied the compiled binary to vmhost.

dev@dev:~/Bugzilla_1217492> rpm -qa|grep libusb-1_0-devel libusb-1_0-devel-1.0.24-150400.3.3.1.x86_64

vmhost:~/Bugzilla_1217492 # rpm -qa|grep libusb-1 libusb-1_0-0-1.0.24-150400.3.3.1.x86_64

- The Conbee II is the only USB device attached to vmhost during the test. It was no attached to any vm and was in exclusive use by vmhost after a clean reboot. -- You are receiving this mail because: You are on the CC list for the bug.