https://bugzilla.novell.com/show_bug.cgi?id=290279#c11 --- Comment #11 from Marcelo Borro <marcelovborro@ig.com.br> 2007-10-10 07:35:31 MST --- Thanks :-) Adding hwprobe=+usb as boot parameter allows me to find the usb sound with 'hwinfo --sound': heliserver:~ # hwinfo --sound 33: USB 00.0: 0401 Multimedia audio controller [Created at usb.122] UDI: /org/freedesktop/Hal/devices/usb_device_d8c_201_noserial_if0 Unique ID: X7GA.VsPijs0Hbo8 Parent ID: k4bc.hL0pXfs9d15 SysFS ID: /devices/pci0000:00/0000:00:02.0/usb1/1-7/1-7:1.0 SysFS BusID: 1-7:1.0 Hardware Class: sound Model: "C-Media Electronics PnP Audio Device" Hotplug: USB Vendor: usb 0x0d8c "C-Media Electronics, Inc." Device: usb 0x0201 "PnP Audio Device" Revision: "0.10" Driver: "snd-usb-audio" Driver Modules: "snd_usb_audio" Speed: 12 Mbps Module Alias: "usb:v0D8Cp0201d0010dc00dsc00dp00ic01isc01ip00" Driver Info #0: Driver Status: snd_usb_audio is active Driver Activation Cmd: "modprobe snd_usb_audio" Config Status: cfg=no, avail=yes, need=no, active=unknown Attached to: #31 (Hub) BUT it still do not show on yast and alsaconf, so there's no sound yet. Checking over the Internet, I found several reposrts on Ubuntu, but the sound is identified by alsa on Ubuntu. I think that this is all I need: How to make alsa use the snd-usb-audio if alsaconf or yast do not lists it? -- Configure bugmail: https://bugzilla.novell.com/userprefs.cgi?tab=email ------- You are receiving this mail because: ------- You are on the CC list for the bug.