https://bugzilla.novell.com/show_bug.cgi?id=305405#c3 Steven Beattie <sbeattie@novell.com> changed: What |Removed |Added ---------------------------------------------------------------------------- CC| |teheo@novell.com Component|Installation |Kernel Summary|install fails on ThinkPad T43 |ahci module fails on ThinkPad T43 sata | |controller [82801FBM (ICH6M)] --- Comment #3 from Steven Beattie <sbeattie@novell.com> 2007-08-30 08:25:47 MST --- [changing the summary to reflect where the problem lies.] Okay, thanks, Glenn, for the confirmation. The ahci module is not working properly with the SATA controller in the T43, as none of the devices attached to it are recognized. However, the ata_piix module works with this chipset. Here's the lspci -vv output for the controller on my T43: 00:1f.2 IDE interface: Intel Corporation 82801FBM (ICH6M) SATA Controller (rev 03) (prog-if 80 [Master]) Subsystem: IBM Unknown device 056a Control: I/O+ Mem- BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B- Status: Cap+ 66MHz+ UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR- <PERR- Latency: 0 Region 0: I/O ports at 01f0 [size=8] Region 1: I/O ports at 03f4 [size=1] Region 2: I/O ports at 0170 [size=8] Region 3: I/O ports at 0374 [size=1] Region 4: I/O ports at 18c0 [size=16] Capabilities: [70] Power Management version 2 Flags: PMEClk- DSI- D1- D2- AuxCurrent=0mA PME(D0-,D1-,D2-,D3hot+,D3cold-) Status: D0 PME-Enable- DSel=0 DScale=0 PME- Tejun: can we either fix support for this chipset or blacklist it so it uses the ata_piix module by default? I'm assuming you're the right contact for this since you added the libata support to our kernel. Thanks. -- Configure bugmail: https://bugzilla.novell.com/userprefs.cgi?tab=email ------- You are receiving this mail because: ------- You are on the CC list for the bug.