https://bugzilla.novell.com/show_bug.cgi?id=883528 https://bugzilla.novell.com/show_bug.cgi?id=883528#c6 Freek de Kruijf <freek@opensuse.org> changed: What |Removed |Added ---------------------------------------------------------------------------- Status|NEEDINFO |NEW InfoProvider|freek@opensuse.org | --- Comment #6 from Freek de Kruijf <freek@opensuse.org> 2014-06-27 11:24:48 UTC --- I meant item 2. When starting the system and the grub2 timeout elapses the default system is the system that will be booted. I installed Factory which generates a new grub2 where Factory will be the default system to boot after timeout. After several times booting Factory I wanted the default system to boot to be 13.1, so I used YaST in Factory to change the default from Factory to 13.1. I also have a 12.3 and 12.2 system, which are also present in the grup2 bootmenu. However YaST shows that the 13.1 is the default system, but when booting the computer I have to select 13.1 to boot that system. After the timeout Factory will be booted. I also tried to generate a new grub2 in 13.1 using YaST, it shows 13.1 is the default to be booted system, however nothing changes and after the timeout Factory will be booted. So also the bootloader of YaST in 13.1 is at fault. I tried changing the default to Factory, generated a new grub2, started the bootloader module again, changed the default system back to 13.1 and generated a new grub2, all in 13.1. But no avail. After a timeout Factory will be booted. Only after a forced (re)installation of mdadm in Factory, I got a grub2 that boots 13.1 after the timeout. -- Configure bugmail: https://bugzilla.novell.com/userprefs.cgi?tab=email ------- You are receiving this mail because: ------- You are on the CC list for the bug.