https://bugzilla.novell.com/show_bug.cgi?id=419095 Summary: network bonding is broken in yast2-setup, and does not work in xen Product: openSUSE 11.0 Version: Final Platform: x86-64 OS/Version: openSUSE 11.0 Status: NEW Severity: Normal Priority: P5 - None Component: Network AssignedTo: bnc-team-screening@forge.provo.novell.com ReportedBy: schueffler@softgarden.de QAContact: qa@suse.de Found By: --- Created an attachment (id=234645) --> (https://bugzilla.novell.com/attachment.cgi?id=234645) dmesg of xen-boot showing bonding errors After upgrading from 10.3 to 11.0, i can not setup network bonding using yast2 anymore. The bonding setup page simply does not show the two network cards in the selection-field "enslaved/bound interfaces" at all. In my 10.3-setup this worked fine, but after upgrading to 11.0 it is not working. Nevertheless, setting the /etc/sysconfig/network/ifcfg-bond0 manually to the desired values works as expected only when booting to native kernel. When booting to xen-based kernel, a symlink-file ifcfg-pbond0 will be created automatically during boot (pointing to ifcfg-bond0), and then some error lines about mising /sys/class/net/eth1/bonding/slaves will be printed, and the system does not have network access to the outside world. Also it tries to activate bonding twice: one time initiated by the original ifcfg-bond0-file, and second by the automatically created pbond0-file. It fails in both cases, thus ending in a network-less setup.... I attached the dmesg of such a boot which shows this procedure. So, this actually are two problems in one bug-report: i am not able to use yast2-network-setup as expected, and network bonding using xen is not working at all (although i am not 100% sure if my "manual" setup (editing the bond-config-file) is sufficient or if i missed some setup-steps especially for xen) -- Configure bugmail: https://bugzilla.novell.com/userprefs.cgi?tab=email ------- You are receiving this mail because: ------- You are on the CC list for the bug.