http://bugzilla.novell.com/show_bug.cgi?id=601501 http://bugzilla.novell.com/show_bug.cgi?id=601501#c14 --- Comment #14 from Vladimir Botka <vbotka@novell.com> 2010-05-27 22:45:09 UTC --- (In reply to comment #13) I have enabled debug on iwl3945 and tried to connect WPA-EAP "Novel" network. Packets were sniffed from the air. I was not able to connect either with NM on channel 44 or on channel 11 with ifup/ifdown. In both cases the iwl3945 driver repeatedly "deauthenticated" with "Unspecified reason"reason=1 . On channel 44 the AP responded to the "probe request" but the STA did not try to associate. On channel 11 there was no response from the Novell AP to the "probe request" ! This is all I can tell for sure now. To investigate these kind of problems is rather time consuming. I will have to setup WPA-EAP authentication backend on my own and try to reproduce with the WPA-EAP under control. Just few more notes for the record (a) "iw list" shows that only passive scanning is allowed on channel 44 5220 MHz [44] (14.0 dBm) (passive scanning, no IBSS) (b) https://patchwork.kernel.org/patch/96097/ states: Some firmware versions don't behave properly when passive scanning is requested on radar channels without enabling active scanning on receiving a good frame. Work around that issue by asking the firmware to only enable the active scanning after receiving a huge number of good frames, a number that can never be reached during our dwell time. [1] wlan0: deauthenticating from 00:1a:1e:a6:fa:29 by local choice (reason=1) -- Configure bugmail: http://bugzilla.novell.com/userprefs.cgi?tab=email ------- You are receiving this mail because: ------- You are on the CC list for the bug.